[PATCH v10 06/11] drm: bridge/dw_hdmi: clear i2cmphy_stat0 reg in hdmi_phy_wait_i2c_done

Andy Yan andy.yan at rock-chips.com
Thu Nov 13 19:27:59 PST 2014


HDMI_IH_I2CMPHY_STAT0 is a clear on write register, which indicates i2cm
operation status(i2c transfer done or error), every hdmi phy register
configuration must check this register to make sure the configuration
has complete. But the indication bit should be cleared after check, otherwise
the corresponding bit will hold on forever, this may give a wrong signal for
next check.

Signed-off-by: Andy Yan <andy.yan at rock-chips.com>
---

Changes in v10: None
Changes in v9: None
Changes in v8: None
Changes in v7: None
Changes in v6: None
Changes in v5: None
Changes in v4: None
Changes in v3: None
Changes in v2: None

 drivers/gpu/drm/bridge/dw_hdmi.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/bridge/dw_hdmi.c b/drivers/gpu/drm/bridge/dw_hdmi.c
index 05e7156..4f9a5c0 100644
--- a/drivers/gpu/drm/bridge/dw_hdmi.c
+++ b/drivers/gpu/drm/bridge/dw_hdmi.c
@@ -640,11 +640,15 @@ static inline void hdmi_phy_test_dout(struct dw_hdmi *hdmi,
 
 static bool hdmi_phy_wait_i2c_done(struct dw_hdmi *hdmi, int msec)
 {
-	while ((hdmi_readb(hdmi, HDMI_IH_I2CMPHY_STAT0) & 0x3) == 0) {
+	u32 val;
+
+	while ((val = hdmi_readb(hdmi, HDMI_IH_I2CMPHY_STAT0) & 0x3) == 0) {
 		if (msec-- == 0)
 			return false;
 		udelay(1000);
 	}
+	hdmi_writeb(hdmi, val, HDMI_IH_I2CMPHY_STAT0);
+
 	return true;
 }
 
-- 
1.9.1




More information about the Linux-rockchip mailing list