[PATCH v8 2/5] riscv_cbqri: resctrl: Add cache allocation via capacity block mask

[Drew Fustini]

On Wed, Sep 23, 2026 at 05:13:15PM +0800, yunhui cui wrote:
> Hi Fustini,
> 
> On Fri, Sep 18, 2026 at 12:41 AM Drew Fustini <fustini at kernel.org> wrote:
> >
> > Wire CBQRI capacity controllers into resctrl as RDT_RESOURCE_L2 and
> > RDT_RESOURCE_L3 schemata.
> >
> > resctrl exposes a single capacity mask per resource, so when more than
> > one capacity controller backs a cache level they must report the same
> > number of capacity blocks. The same holds for the other capabilities
> > resctrl exposes once per resource. A level whose controllers disagree
> > is left unexposed. Other levels are unaffected.
> >
> > Control domains are created in the cpuhp online callback and keyed on
> > the onlining CPU's cache id from cacheinfo, so a CPU that is offline at
> > probe time still joins its domain once it comes online. A domain is
> > published on the ctrl_domains RCU list only after it is fully
> > initialized and brought online, and removed from the list before it is
> > taken offline, following the documented safe traversal rules.
> >
> > Assisted-by: LLM
> > Tested-by: Chen Pei <cp0613 at linux.alibaba.com>
> > Co-developed-by: Adrien Ricciardi <aricciardi at baylibre.com>
> > Signed-off-by: Adrien Ricciardi <aricciardi at baylibre.com>
> > Signed-off-by: Drew Fustini <fustini at kernel.org>
> > ---
> >  MAINTAINERS                      |   2 +
> >  arch/riscv/include/asm/resctrl.h | 147 ++++++++
> >  drivers/resctrl/Kconfig          |   4 +
> >  drivers/resctrl/Makefile         |   1 +
> >  drivers/resctrl/cbqri_resctrl.c  | 785 +++++++++++++++++++++++++++++++++++++++
> >  5 files changed, 939 insertions(+)
[..]
> > diff --git a/drivers/resctrl/cbqri_resctrl.c b/drivers/resctrl/cbqri_resctrl.c
[..]
> > +/*
> > + * Note about terminology between x86 (Intel RDT/AMD QoS) and RISC-V:
> > + *   CLOSID on x86 is RCID on RISC-V
> > + *     RMID on x86 is MCID on RISC-V
> > + */
> > +u32 resctrl_arch_get_num_closid(struct rdt_resource *res)
> > +{
> > +       struct cbqri_resctrl_res *hw_res;
> > +
> > +       hw_res = container_of(res, struct cbqri_resctrl_res, resctrl_res);
> > +
> > +       if (!hw_res->ctrl)
> > +               return 0;
> > +
> > +       return hw_res->ctrl->rcid_count;
> > +}
> 
> When CDP is enabled, the resctrl core halves the value returned by
> resctrl_arch_get_num_closid(). Is that correct for CBQRI?
> CBQRI v1.0 defines allocation using an (RCID, AT) pair, and its example
> uses the same RCID=5 for separate AT=0 and AT=1 allocations.
> 
> Thanks,
> Yunhui

You're right that this is not needed for RISC-V. CDP is still functional
but the upper half of RCIDs is unused.

It would require an fs/resctrl change to make the halving conditional.
Therefore, I would like to deal with that in a separate series and not
expand the scope of this series. I will add a comment above
resctrl_arch_get_num_closid() for v9, so the current situation is
obvious.

Thanks,
Drew