[PATCH 1/2] riscv: dts: spacemit: Fix phy id check for the phy on pico-itx board

[Andrew Lunn]

On Sat, Jul 25, 2026 at 08:58:02AM +0800, Inochi Amaoto wrote:
> Current phy framework can not reinit the phy correctly, as it will
> assert the phy reset GPIO so the phy id can not be readed. Setting
> the phy id of board pico-itx manually so the phy id dectection can
> be skipped.
> 
> Fixes: 74657a376960 ("riscv: dts: spacemit: Add ethernet device for K3")
> Reported-by: E Shattow <e at freeshell.de>
> Reported-by: Inochi Amaoto <inochiama at gmail.com>
> Closes: https://lore.kernel.org/netdev/20260712045233.800748-1-inochiama@gmail.com
> Signed-off-by: Inochi Amaoto <inochiama at gmail.com>
> Tested-by: E Shattow <e at freeshell.de>
> ---
>  arch/riscv/boot/dts/spacemit/k3-pico-itx.dts | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
> index b2a7d2d0d3a8..b9d2de878f38 100644
> --- a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
> +++ b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
> @@ -196,7 +196,8 @@ &eth0 {
>  
>  	mdio {
>  		phy0: phy at 1 {
> -			compatible = "ethernet-phy-ieee802.3-c22";
> +			compatible = "ethernet-phy-id001c.c916",
> +				     "ethernet-phy-ieee802.3-c22";

There was a patch recently from one of the DT Maintainers removing the
-c22 compatible when there was a specific PHY ID. I did not look into
why. Does this pass all the binding tool checks?

     Andrew