[PATCH 2/2] riscv: dts: spacemit: Fix phy id check for the phy on com260 board

[Inochi Amaoto]

Current phy framework can not reinit the phy correctly, as it will
assert the phy reset GPIO so the phy id can not be readed. Setting
the phy id of board com260 manually so the phy id dectection can
be skipped.

Fixes: cfe5c91cb73c ("riscv: dts: spacemit: k3: Initial support for CoM260-IFX board")
Signed-off-by: Inochi Amaoto <inochiama at gmail.com>
---
 arch/riscv/boot/dts/spacemit/k3-com260.dtsi | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
index b704b537385c..a26b18aabec1 100644
--- a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
@@ -174,7 +174,8 @@ &eth1 {
 
 	mdio {
 		phy1: phy at 1 {
-			compatible = "ethernet-phy-ieee802.3-c22";
+			compatible = "ethernet-phy-id001c.c916",
+				     "ethernet-phy-ieee802.3-c22";
 			reg = <1>;
 			reset-gpios = <&gpio 1 5 GPIO_ACTIVE_LOW>;
 			reset-assert-us = <10000>;
-- 
2.55.0