[PATCH 1/1] net: spacemit: display phy driver information

[Chukun Pan]

Hi,

> > Print the PHY driver used and interrupt status after connection.
>
> The standard way to do this is call phy_attached_info(). Is it missing
> some information you need?

I initially used phy_attached_info(), but it was too long and printed
phydev_name() "cac80000.ethernet:01" twice:

YT8531 Gigabit Ethernet cac80000.ethernet:01: attached PHY driver (mii_bus:phy_addr=cac80000.ethernet:01, irq=POLL)

So I referenced a part of phylink_bringup_phy() to make it look better:

k1_emac cac80000.ethernet eth0: PHY driver [YT8531 Gigabit Ethernet] (irq=POLL)
k1_emac cac80000.ethernet eth0: Link is Up - 1Gbps/Full - flow control off

If we're going to use phy_attached_info(), I think `mii_bus:phy_addr`
is redundant. What's your opinion on this?

Thanks,
Chukun