[PATCH v4 10/11] riscv: dts: spacemit: add initial device tree of SpacemiT K3 SoC

[Guodong Xu]

On Mon, Jan 12, 2026 at 3:43 PM Maud Spierings
<maud_spierings at hotmail.com> wrote:
>
> > +             mimsic: interrupt-controller at f1000000 {
> > +                     compatible = "spacemit,k3-imsics", "riscv,imsics";
> > +                     reg = <0x0 0xf1000000 0x0 0x10000>;
> > +                     #interrupt-cells = <0>;
> > +                     #msi-cells = <0>;
> > +                     interrupt-controller;
> > +                     interrupts-extended = <&cpu0_intc 11>, <&cpu1_intc 11>,
> > +                                           <&cpu2_intc 11>, <&cpu3_intc 11>,
> > +                                           <&cpu4_intc 11>, <&cpu5_intc 11>,
> > +                                           <&cpu6_intc 11>, <&cpu7_intc 11>;
> > +                     msi-controller;
> > +                     riscv,guest-index-bits = <6>;
> > +                     riscv,hart-index-bits = <4>;
> > +                     riscv,num-guest-ids = <511>;
> > +                     riscv,num-ids = <511>;
> > +
> > +                     status = "disabled";
> > +             };
> > +
> > +             maplic: interrupt-controller at f1800000 {
> > +                     compatible = "spacemit,k3-aplic", "riscv,aplic";
> > +                     reg = <0x0 0xf1800000 0x0 0x4000>;
> > +                     #interrupt-cells = <2>;
> > +                     interrupt-controller;
> > +                     msi-parent = <&mimsic>;
> > +                     riscv,children = <&saplic>;
> > +                     riscv,delegate = <&saplic 1 512>;
> > +                     riscv,num-sources = <512>;
> > +
> > +                     status = "disabled";
> > +             };
>
>
> from reading the chatter on v3 I think the right status here may be
> "reserved", for elements that are reserved by firmware. But I could be
> mistaken.

Thanks Maud. Good catch. I think you are right, both M-mode maplic and mimsic
should be listed as "reserved" to signify that they are intended to be used
in OpenSBI, not the S-mode kernel.

I will fix that in the next version.

BR,
Guodong Xu

>
> Kind regards,
> Maud