[PATCH v2 3/3] riscv: dts: spacemit: enable USB3 on OrangePi RV2

[Yixun Lan]

Hi Chukun,

On 18:00 Thu 02 Apr     , Chukun Pan wrote:
> Enable the DWC3 USB3.0 controller and its associated PHY on
> the OrangePi RV2. The onboard GENESYS GL3523 Hub provides 3
> USB3 Type-A ports. Enable the corresponding VBUS regulator.

Can you work with Han for adding USB support[1]? this will simply
distribute our effort, and make the review process even harder

https://lore.kernel.org/all/0ec229e2fb138092672773f134d0739e70740ce0.1774974017.git.gaohan@iscas.ac.cn/ [1]
> 
> Signed-off-by: Chukun Pan <amadeus at jmu.edu.cn>
> ---
>  .../boot/dts/spacemit/k1-orangepi-rv2.dts     | 24 +++++++++++++++++++
>  1 file changed, 24 insertions(+)
> 
> diff --git a/arch/riscv/boot/dts/spacemit/k1-orangepi-rv2.dts b/arch/riscv/boot/dts/spacemit/k1-orangepi-rv2.dts
> index 929b70d384b5..ab835c30dd86 100644
> --- a/arch/riscv/boot/dts/spacemit/k1-orangepi-rv2.dts
> +++ b/arch/riscv/boot/dts/spacemit/k1-orangepi-rv2.dts
> @@ -52,6 +52,20 @@ vcc4v0: regulator-vcc4v0 {
>  		regulator-max-microvolt = <4000000>;
>  		vin-supply = <&vcc_5v0>;
>  	};
> +
> +	vcc5v0_usb30: regulator-vcc5v0-usb30 {
> +		compatible = "regulator-fixed";
> +		regulator-name = "vcc5v0_usb30";
> +		enable-active-high;
> +		gpios = <&gpio K1_GPIO(123) GPIO_ACTIVE_HIGH>;
> +		regulator-min-microvolt = <5000000>;
> +		regulator-max-microvolt = <5000000>;
> +		vin-supply = <&vcc_5v0>;
> +	};
> +};
> +
> +&combo_phy {
> +	status = "okay";
>  };
>  
>  &eth0 {
> @@ -111,3 +125,13 @@ &uart0 {
>  	pinctrl-0 = <&uart0_2_cfg>;
>  	status = "okay";
>  };
> +
> +&usbphy2 {
> +	status = "okay";
> +};
> +
> +&usb_dwc3 {
> +	dr_mode = "host";
> +	vbus-supply = <&vcc5v0_usb30>;
IMO, the vbus doesn't directly tie to dwc3 host, but to HUB's port
so I think this is still wrong, although it may work on the board..

> +	status = "okay";
> +};
> -- 
> 2.34.1
> 
> 

-- 
Yixun Lan (dlan)