[PATCH v6 0/7] Introduce SpacemiT K1 PCIe phy and host controller

[Alex Elder]

On 11/14/25 10:21 PM, Jason Montleon wrote:
> On Thu, Nov 13, 2025 at 4:45 PM Alex Elder <elder at riscstar.com> wrote:
>>
>> This series introduces a PHY driver and a PCIe driver to support PCIe
>> on the SpacemiT K1 SoC.  The PCIe implementation is derived from a
>> Synopsys DesignWare PCIe IP.  The PHY driver supports one combination
>> PCIe/USB PHY as well as two PCIe-only PHYs.  The combo PHY port uses
>> one PCIe lane, and the other two ports each have two lanes.  All PCIe
>> ports operate at 5 GT/second.
>>
>> The PCIe PHYs must be configured using a value that can only be
>> determined using the combo PHY, operating in PCIe mode.  To allow
>> that PHY to be used for USB, the needed calibration step is performed
>> by the PHY driver automatically at probe time.  Once this step is done,
>> the PHY can be used for either PCIe or USB.
>>
>> The driver supports 256 MSIs, and initially does not support PCI INTx
>> interrupts.  The hardware does not support MSI-X.
>>
>> Version 6 of this series addresses a few comments from Christophe
>> Jaillet, and improves a workaround that disables ASPM L1.  The two
>> people who had reported errors on earlier versions of this code have
>> confirmed their NVMe devices now work when configured with the default
>> RISC-V kernel configuration.
> 
> I successfully tested this patchset on a Banana Pi F3 and also a
> Milk-V M1 Jupiter by making the same additions to k1-milkv-jupiter.dts
> as were made to k1-bananapi-f3.dts.
> I no longer have problems with NVME devices like I did when I tried v3 and v4.
> 
> Tested-by: Jason Montleon <jmontleo at redhat.com>

Thank you very much for testing this.  Your Tested-by is included
in Mani's commit.

					-Alex