[PATCH v3] pinctrl: spacemit: enable config option

[Alex Elder]

On 3/17/25 3:18 AM, Geert Uytterhoeven wrote:
> Hi Yixun,
> 
> Thanks for your patch, which is now commit 7ff4faba63571c51
> ("pinctrl: spacemit: enable config option") in v6.14-rc7.
> 
> On Tue, 18 Feb 2025 at 01:32, Yixun Lan <dlan at gentoo.org> wrote:
>> Pinctrl is an essential driver for SpacemiT's SoC,
>> The uart driver requires it, same as sd card driver,
>> so let's enable it by default for this SoC.
>>
>> The CONFIG_PINCTRL_SPACEMIT_K1 isn't enabled when using
>> 'make defconfig' to select kernel configuration options.
>> This result in a broken uart driver where fail at probe()
>> stage due to no pins found.
> 
> Perhaps this is an issue with the uart driver?
> I just disabled CONFIG_PINCTRL_RZA2 on RZA2MEVB (which is one of the
> few Renesas platforms where the pin control driver is not enabled by
> default, for saving memory), and the system booted fine into a Debian
> nfsroot.  Probe order of some devices did change, and "Trying to
> probe devices needed for running init" was printed.
> 
>> Fixes: a83c29e1d145 ("pinctrl: spacemit: add support for SpacemiT K1 SoC")
>> Reported-by: Alex Elder <elder at kernel.org>
>> Acked-by: Conor Dooley <conor.dooley at microchip.com>
>> Tested-by: Alex Elder <elder at riscstar.com>
>> Signed-off-by: Yixun Lan <dlan at gentoo.org>
> 
>> --- a/drivers/pinctrl/spacemit/Kconfig
>> +++ b/drivers/pinctrl/spacemit/Kconfig
>> @@ -4,9 +4,10 @@
>>   #
>>
>>   config PINCTRL_SPACEMIT_K1
>> -       tristate "SpacemiT K1 SoC Pinctrl driver"
>> +       bool "SpacemiT K1 SoC Pinctrl driver"
>>          depends on ARCH_SPACEMIT || COMPILE_TEST
>>          depends on OF
>> +       default y
> 
> Ouch, fix sent...
> "[PATCH] pinctrl: spacemit: PINCTRL_SPACEMIT_K1 should not default to
> y unconditionally"
> https://lore.kernel.org/6881b8d1ad74ac780af8a974e604b5ef3f5d4aad.1742198691.git.geert+renesas@glider.be

This is interesting; what you say was what was proposed in v1
of the patch series.

I did not understand COMPILE_TEST to be used the way you say,
but I think that just means you understood it better than I do.

I think the rule is that "depends on FOO || COMPILE_TEST" alone
is fine.  But if you are going to specify a default, it should
be "default FOO" and not "default y".

Thanks for pointing this out.  I'll go respond to your patch.

					-Alex

>>          select GENERIC_PINCTRL_GROUPS
>>          select GENERIC_PINMUX_FUNCTIONS
>>          select GENERIC_PINCONF
> 
> Gr{oetje,eeting}s,
> 
>                          Geert
>