[PATCH net-next v2 00/18] Support the Cadence MACB/GEM instances on Mobileye EyeQ5 SoCs
Théo Lebrun
theo.lebrun at bootlin.com
Fri Jun 27 02:08:46 PDT 2025
Mobileye EyeQ5 SoCs provides two GEM IP blocks. The end result of this
series is working 1G networking on the EyeQ5 eval board. It isn't just
a new macb_config & compatible, we also provide some cleanup & fixes
along the way.
dt-bindings:
[PATCH net-next v2 01/18] dt-bindings: net: cdns,macb: sort compatibles
[PATCH net-next v2 02/18] dt-bindings: net: cdns,macb: add Mobileye EyeQ5 ethernet interface
[PATCH net-next v2 03/18] dt-bindings: net: cdns,macb: allow tsu_clk without tx_clk
[PATCH net-next v2 04/18] dt-bindings: net: cdns,macb: allow dma-coherent
Cleanup:
[PATCH net-next v2 05/18] net: macb: use BIT() macro for capability definitions
[PATCH net-next v2 06/18] net: macb: Remove local variables clk_init and init in macb_probe()
[PATCH net-next v2 07/18] net: macb: drop macb_config NULL checking
[PATCH net-next v2 08/18] net: macb: introduce DMA descriptor helpers (is 64bit? is PTP?)
[PATCH net-next v2 09/18] net: macb: sort #includes
Fixes:
[PATCH net-next v2 10/18] net: macb: remove illusion about TBQPH/RBQPH being per-queue
[PATCH net-next v2 11/18] net: macb: single dma_alloc_coherent() for DMA descriptors
[PATCH net-next v2 12/18] net: macb: match skb_reserve(skb, NET_IP_ALIGN) with HW alignment
[PATCH net-next v2 13/18] net: macb: avoid double endianness swap in macb_set_hwaddr()
EyeQ5 support:
[PATCH net-next v2 14/18] net: macb: add no LSO capability (MACB_CAPS_NO_LSO)
[PATCH net-next v2 15/18] net: macb: Add "mobileye,eyeq5-gem" compatible
DTS:
[PATCH net-next v2 16/18] MIPS: mobileye: add EyeQ5 DMA IOCU support
[PATCH net-next v2 17/18] MIPS: mobileye: eyeq5: add two Cadence GEM Ethernet controllers
[PATCH net-next v2 18/18] MIPS: mobileye: eyeq5-epm: add two Cadence GEM Ethernet PHYs
Note: I've categorised [PATCH 12/18] as a fix, but it is also mandatory
for working GEM on EyeQ5 SoCs. Hardware is RSC capable so we mustn't do
the skb_reserve(). It probably is the first platform where
NET_IP_ALIGN=2 and the devices are RSC capable.
Note: I did not extract the platform specific code (2 syscon registers
being written to) from macb_config->init into separate resources. I
cannot dissociate that register write sequence into something more
fluid (modeling clocks/PHYs).
Have a nice day,
Théo
Signed-off-by: Théo Lebrun <theo.lebrun at bootlin.com>
---
Changes in v2:
- Rebase upon latest net-next (1ea2e106130a).
- dt-bindings:
- Add description to mobileye,olb phandle, following a
`make dt_binding_check` warning reported by Rob's bot.
- Add "sort compatibles" patch.
- Take "Acked-by: Rob Herring" on dma-coherent patch.
- Improve "allow tsu_clk without tx_clk" commit message following
Rob's comment.
- Take "Reviewed-by: Andrew Lunn" trailer on four patches:
net: macb: use BIT() macro for capability definitions
net: macb: add no LSO capability (MACB_CAPS_NO_LSO)
net: macb: sort #includes
MIPS: mobileye: eyeq5-epm: add two Cadence GEM Ethernet PHYs
- net: macb:
- Split:
simplify macb_probe() code touching match data
into two commits, following comment by Andrew:
Remove local variables clk_init and init in macb_probe()
drop macb_config NULL checking
- Replace match-data IP alignment value by a more robust solution: HW support
IP alignment if it does not support RSC.
- use regmap_update_bits() for OLB register writes.
- fix insertion order of compatible.
- fix LSO detection comment.
- move local variables `struct macb_dma_desc_64` inside conditionals,
in macb_{get,get}_addr().
- add "remove illusion about TBQPH/RBQPH being per-queue" commit.
- add "single dma_alloc_coherent() for DMA descriptors" commit.
- add "avoid double endianness swap in macb_set_hwaddr()" commit.
- DTS: lowercase reg properties of PHYs.
- Link to v1: https://lore.kernel.org/r/20250321-macb-v1-0-537b7e37971d@bootlin.com
---
Théo Lebrun (18):
dt-bindings: net: cdns,macb: sort compatibles
dt-bindings: net: cdns,macb: add Mobileye EyeQ5 ethernet interface
dt-bindings: net: cdns,macb: allow tsu_clk without tx_clk
dt-bindings: net: cdns,macb: allow dma-coherent
net: macb: use BIT() macro for capability definitions
net: macb: Remove local variables clk_init and init in macb_probe()
net: macb: drop macb_config NULL checking
net: macb: introduce DMA descriptor helpers (is 64bit? is PTP?)
net: macb: sort #includes
net: macb: remove illusion about TBQPH/RBQPH being per-queue
net: macb: single dma_alloc_coherent() for DMA descriptors
net: macb: match skb_reserve(skb, NET_IP_ALIGN) with HW alignment
net: macb: avoid double endianness swap in macb_set_hwaddr()
net: macb: add no LSO capability (MACB_CAPS_NO_LSO)
net: macb: Add "mobileye,eyeq5-gem" compatible
MIPS: mobileye: add EyeQ5 DMA IOCU support
MIPS: mobileye: eyeq5: add two Cadence GEM Ethernet controllers
MIPS: mobileye: eyeq5-epm: add two Cadence GEM Ethernet PHYs
.../devicetree/bindings/net/cdns,macb.yaml | 38 ++-
MAINTAINERS | 2 +-
arch/mips/boot/dts/mobileye/eyeq5-epm5.dts | 26 ++
arch/mips/boot/dts/mobileye/eyeq5.dtsi | 34 ++
arch/mips/mobileye/Kconfig | 1 +
arch/mips/mobileye/Makefile | 2 +
arch/mips/mobileye/eyeq5-iocu-dma.c | 160 +++++++++
drivers/net/ethernet/cadence/macb.h | 56 ++-
drivers/net/ethernet/cadence/macb_main.c | 380 ++++++++++++---------
9 files changed, 498 insertions(+), 201 deletions(-)
---
base-commit: bb26d1066f9db96d9b10d7724798aa14203f3ef8
change-id: 20250311-macb-65a7fa86af1d
Best regards,
--
Théo Lebrun <theo.lebrun at bootlin.com>
More information about the linux-riscv
mailing list