[PATCH 5/8] riscv: dts: spacemit: Add dma bus and PDMA node for K1 SoC

Yixun Lan dlan at gentoo.org
Fri Jun 13 06:22:27 PDT 2025


Hi Vivian, Guodong,

On 11:06 Fri 13 Jun     , Vivian Wang wrote:
> Hi Guodong,
> 
> On 6/11/25 20:57, Guodong Xu wrote:
> > <snip>
> >
> > -			status = "disabled";
> > +		dma_bus: bus at 4 {
> > +			compatible = "simple-bus";
> > +			#address-cells = <2>;
> > +			#size-cells = <2>;
> > +			dma-ranges = <0x0 0x00000000 0x0 0x00000000 0x0 0x80000000>,
> > +				     <0x1 0x00000000 0x1 0x80000000 0x3 0x00000000>;
> > +			ranges;
> >  		};
> 
> Can the addition of dma_bus and movement of nodes under it be extracted
> into a separate patch, and ideally, taken up by Yixun Lan without going
> through dmaengine? Not specifically "dram_range4", but all of these
> translations affects many devices on the SoC, including ethernet and
> USB3. See:
Right, we've had an offline discussion, and agreed on this - have *bus
patches separated and let other patches depend on it.

But seems Guodong failed to do this or just sent out an old version
of the PDMA patch?

> 
> https://lore.kernel.org/all/20250526-b4-k1-dwc3-v3-v4-2-63e4e525e5cb@whut.edu.cn/
> https://lore.kernel.org/all/20250613-net-k1-emac-v1-0-cc6f9e510667@iscas.ac.cn/
> 
> (I haven't put eth{0,1} under dma_bus5 because in 6.16-rc1 there is
> none, but ideally we should fix this.)
> 
> DMA address translation does not depend on PDMA. It would be best if we
> get all the possible dma-ranges buses handled in one place, instead of
> everyone moving nodes around.
> 
I agree

> @Ze Huang: This affects your "MBUS" changes as well. Please take a look,
> thanks.
> 
> >  
> >  		gpio: gpio at d4019000 {
> > @@ -792,3 +693,124 @@ pwm19: pwm at d4022c00 {
> >  		};
> >  	};
> >  };
> > +
> > +&dma_bus {
> >
> > <snip>
> 

-- 
Yixun Lan (dlan)



More information about the linux-riscv mailing list