[PATCH net-next 2/2] net: mdio-mux: Add MDIO mux driver for Sophgo CV1800 SoCs

Andrew Lunn andrew at lunn.ch
Wed Jun 11 09:13:00 PDT 2025


On Wed, Jun 11, 2025 at 04:02:00PM +0800, Inochi Amaoto wrote:
> Add device driver for the mux driver for Sophgo CV18XX/SG200X
> series SoCs.
> 
> @@ -0,0 +1,119 @@
> +// SPDX-License-Identifier: GPL-2.0
> +/*
> + * Sophgo CV1800 MDIO multiplexer driver
> + *
> + * Copyright (C) 2025 Inochi Amaoto <inochiama at gmail.com>
> + */
> +
> +#include <linux/bitfield.h>
> +#include <linux/bits.h>
> +#include <linux/delay.h>
> +#include <linux/clk.h>
> +#include <linux/io.h>
> +#include <linux/mdio-mux.h>
> +#include <linux/module.h>
> +#include <linux/platform_device.h>
> +
> +#define EPHY_PAGE_SELECT		0x07c
> +#define EPHY_CTRL			0x800
> +#define EPHY_REG_SELECT			0x804
> +
> +#define EPHY_PAGE_SELECT_SRC		GENMASK(12, 8)
> +
> +#define EPHY_CTRL_ANALOG_SHUTDOWN	BIT(0)
> +#define EPHY_CTRL_USE_EXTPHY		BIT(7)
> +#define EPHY_CTRL_PHYMODE		BIT(8)
> +#define EPHY_CTRL_PHYMODE_SMI_RMII	1
> +#define EPHY_CTRL_EXTPHY_ID		GENMASK(15, 11)

There are a lot of defines here which are not used, but as far as i
see, there is one 8bit register, where bit 7 controls the mux.

It looks like you can throw this driver away and just use
mdio-mux-mmioreg.c. This is from the binding documentation with a few
tweaks:

   mdio-mux at 3009000 {
        compatible = "mdio-mux-mmioreg", "mdio-mux";
        mdio-parent-bus = <&xmdio0>;
        #address-cells = <1>;
        #size-cells = <0>;
        reg = <0x3009000 1>;
        mux-mask = <128>;

        mdio at 0 {
            reg = <0>;
            #address-cells = <1>;
            #size-cells = <0>;

            phy_xgmii_slot1: ethernet-phy at 4 {
                compatible = "ethernet-phy-ieee802.3-c45";
                reg = <4>;
            };
        };

        mdio at 128 {
            reg = <128>;
            #address-cells = <1>;
            #size-cells = <0>;

            ethernet-phy at 4 {
                compatible = "ethernet-phy-ieee802.3-c45";
                reg = <4>;
            };
        };
    };

    Andrew



More information about the linux-riscv mailing list