[GIT PULL] RISC-V SpacemiT Devicetrees for v6.14

[Yixun Lan]

Hi Arnd:

> On Wed, Jan 8, 2025, at 15:21, Yixun Lan wrote:
> > Hi Arnd,
> >
> > Here is SpacemiT's device tree changes for 6.14 cycle.
> > All patches have been merged in linux-next tree for testing.
> >
> >
> > ----------------------------------------------------------------
> > RISC-V SpacemiT DT changes for 6.14
> > - basic device tree support
> > - pinctrl dt node info
> > - update MAINTAINERS info
> >
> 
> Sorry for the delay in pulling this. I just had a look and found
> that your branch is based on -rc3 while the soc tree is currently
> using 6.13-rc2. I try hard to avoid unnecessary backmerges of
> upstream contents into my tree, so it would be nice if you could
> rebase it onto 6.13-rc1 or 6.13-rc2 and resend.
> 
sorry, I will keep this in mind, and will rebase to 6.13-rc2

> While looking through the contents, I also found a mistake
> in the contents:
> 
> +++ b/arch/riscv/boot/dts/spacemit/k1.dtsi
> @@ -0,0 +1,459 @@
> ...
> +       aliases {
> +               serial0 = &uart0;
> +               serial1 = &uart2;
> +               serial2 = &uart3;
> +               serial3 = &uart4;
> +               serial4 = &uart5;
> +               serial5 = &uart6;
> +               serial6 = &uart7;
> +               serial7 = &uart8;
> +               serial8 = &uart9;
> +       };
> 
> The aliases here should be in the k1-bananapi-f3.dts file,
> not in the k1.dtsi file, since the mapping between exposed
> UART devices and those available in the chip is board
> specific. You normally want to list only those devices
> that are marked status="okay" on that board.
> 
> I would suggest you fix this in a patch on top of your
> existing commits, but make it part of the pull request.
> 
Ok

>       Arnd

-- 
Yixun Lan (dlan)
Gentoo Linux Developer
GPG Key ID AABEFD55