[PATCH] riscv: dts: starfive: fml13v01: enable pcie1

[Maud Spierings]

On 2/7/25 10:36 AM, Sandie Cao wrote:
> Starfive Soc common defines GPIO28 as pcie1 reset, GPIO21 as pcie1 wakeup;
> But the FML13V01 board uses GPIO21 as pcie1 reset, GPIO28 as pcie1 wakeup;
> redefine pcie1 gpio and enable pcie1 for pcie based Wi-Fi.
>
> Signed-off-by: Sandie Cao<sandie.cao at deepcomputing.io>
> ---
>   .../jh7110-deepcomputing-fml13v01.dts         | 34 +++++++++++++++++++
>   1 file changed, 34 insertions(+)
>
> diff --git a/arch/riscv/boot/dts/starfive/jh7110-deepcomputing-fml13v01.dts b/arch/riscv/boot/dts/starfive/jh7110-deepcomputing-fml13v01.dts
> index 30b0715196b6..8d9ce8b69a71 100644
> --- a/arch/riscv/boot/dts/starfive/jh7110-deepcomputing-fml13v01.dts
> +++ b/arch/riscv/boot/dts/starfive/jh7110-deepcomputing-fml13v01.dts
> @@ -11,6 +11,40 @@ / {
>   	compatible = "deepcomputing,fml13v01", "starfive,jh7110";
>   };
>   
> +&pcie1 {
> +	perst-gpios = <&sysgpio 21 GPIO_ACTIVE_LOW>;
> +	phys = <&pciephy1>;
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pcie1_pins>;
> +	status = "okay";
> +};
> +
> +&sysgpio {
> +	pcie1_pins: pcie1-0 {
> +		clkreq-pins {
> +			pinmux = <GPIOMUX(29, GPOUT_LOW,
> +					      GPOEN_DISABLE,
> +					      GPI_NONE)>;
> +			bias-pull-down;
> +			drive-strength = <2>;
> +			input-enable;
> +			input-schmitt-disable;
> +			slew-rate = <0>;
> +		};
> +
> +		wake-pins {
> +			pinmux = <GPIOMUX(28, GPOUT_HIGH,
> +					      GPOEN_DISABLE,
> +					      GPI_NONE)>;
> +			bias-pull-up;
> +			drive-strength = <2>;
> +			input-enable;
> +			input-schmitt-disable;
> +			slew-rate = <0>;
> +		};
> +	};
> +};
> +
>   &usb0 {
>   	dr_mode = "host";
>   	status = "okay";
>
> base-commit: 2014c95afecee3e76ca4a56956a936e23283f05b


Tried this on my device and it works as expected

Tested-by: Maud Spierings <maud_spierings at hotmail.com>


Kind regards,
Maud