[PATCH v1 0/5] Add Microchip IPC mailbox and remoteproc support

Mathieu Poirier mathieu.poirier at linaro.org
Fri Sep 13 07:44:58 PDT 2024


Hi Valentina,

On Thu, 12 Sept 2024 at 10:48, Valentina Fernandez
<valentina.fernandezalanis at microchip.com> wrote:
>
> Hello all,
>
> This series adds support for the Microchip Inter-Processor Communication
> (IPC) mailbox controller, as well as an IPC remoteproc platform driver.
>
> Microchip's family of RISC-V SoCs typically has one or more clusters
> that can be configured to run in Asymmetric Multi-Processing (AMP) mode.
>
> The Microchip IPC is used to send messages between processors using
> an interrupt signaling mechanism. The driver uses the RISC-V Supervisor
> Binary Interface (SBI) to communicate with software running in machine
> mode (M-mode) to access the IPC hardware block.
>
> Additional details on the Microchip vendor extension and the IPC
> function IDs described in the driver can be found in the following
> documentation:
>
> https://github.com/linux4microchip/microchip-sbi-ecall-extension
>
> The IPC remoteproc platform driver allows for starting and stopping
> firmware on the remote cluster(s) and facilitates RPMsg communication.
> The remoteproc attach/detach operations are also supported for use cases
> where the firmware is loaded by the Hart Software Services
> (zero-stage bootloader) before Linux boots.
>
> Error Recovery and Power Management features are not currently
> supported in the remoteproc platform driver.
>
> The PIC64GX MPU has a Mi-V IHC block, this will be added to the PIC64GX
> dts after the initial upstreaming:
>
> https://patchwork.kernel.org/project/linux-riscv/patch/20240725121609.13101-18-pierre-henry.moussay@microchip.com/
>
> Thanks,
> Valentina
>
> Valentina Fernandez (5):
>   riscv: asm: vendorid_list: Add Microchip Technology to the vendor list
>   dt-bindings: mailbox: add binding for Microchip IPC mailbox driver
>   mailbox: add Microchip IPC support
>   dt-bindings: remoteproc: add binding for Microchip IPC remoteproc
>   remoteproc: add support for Microchip IPC remoteproc platform driver
>
>  .../bindings/mailbox/microchip,sbi-ipc.yaml   | 115 ++++
>  .../remoteproc/microchip,ipc-remoteproc.yaml  |  84 +++
>  arch/riscv/include/asm/vendorid_list.h        |   1 +
>  drivers/mailbox/Kconfig                       |  12 +
>  drivers/mailbox/Makefile                      |   2 +
>  drivers/mailbox/mailbox-mchp-ipc-sbi.c        | 539 ++++++++++++++++++
>  drivers/remoteproc/Kconfig                    |  12 +
>  drivers/remoteproc/Makefile                   |   1 +
>  drivers/remoteproc/mchp_ipc_remoteproc.c      | 461 +++++++++++++++
>  include/linux/mailbox/mchp-ipc.h              |  23 +
>  10 files changed, 1250 insertions(+)

It might be easier to split this patchset in two and proceed
incrementally, i.e upstream the mailbox driver first and then the
remoteproc part.

Regards,
Mathieu

>  create mode 100644 Documentation/devicetree/bindings/mailbox/microchip,sbi-ipc.yaml
>  create mode 100644 Documentation/devicetree/bindings/remoteproc/microchip,ipc-remoteproc.yaml
>  create mode 100644 drivers/mailbox/mailbox-mchp-ipc-sbi.c
>  create mode 100644 drivers/remoteproc/mchp_ipc_remoteproc.c
>  create mode 100644 include/linux/mailbox/mchp-ipc.h
>
> --
> 2.34.1
>



More information about the linux-riscv mailing list