[PATCH 0/7] remove size limit on XIP kernel

[Nam Cao]

On Sun, May 12, 2024 at 05:47:24PM +0200, Alexandre Ghiti wrote:
> XIP kernels are intended for use with flash devices so the XIP_OFFSET
> restriction actually represents the size of the flash device: IIRC this 32MB
> was chosen because it would fit "most devices". I think it would be good to
> come up with a mechanism that allows to restrict the size at build time: a
> config? XIP kernels are custom kernels so the user could enter its flash
> size so that if kernel ends up being too large, it fails. And by default, we
> could a very large size to avoid kernel test robot build failures.

I'm not sure if it is beneficial to do that. Users' flash tool would
complain about the kernel not fitting in flash anyway. I think this would
only make it (a bit more) complicated to build the kernel.

Furthermore XIP_OFFSET at the moment is not the flash size, it is size of
.text (and some other read-only sections). Kernel's data sections are in
flash too, which is copied to RAM during boot.

With the current linker setting, the first 32MB of virtual memory is
occupied by .text. Then at 32MB offset, .data section starts. So if
XIP_OFFSET limit is exceeded, the kernel's size is already way more than
32MB.

Instead, this series moves .data and .text right next to each other (well,
almost, because we need PMD_SIZE alignment). So that if .text size exceed
32MB, the offset that .data resides would increase as well.

If we really want to set flash size during build time (which, again, I
doubt the benefit of), this series would still be relevant: it is not just
removing the size limit, it is also removing the fixed position of the
.data section in virtual address space (in other words, removing the
useless "hole" between .text section and .data section).

Best regards,
Nam