[PATCH v1 2/5] dt-bindings: gpio: mpfs: add coreGPIO support

[Conor Dooley]

From: Jamie Gibbons <jamie.gibbons at microchip.com>

The GPIO controllers on PolarFire SoC were based on the "soft" IP
CoreGPIO, but the inp/outp registers are at different offsets. Add
compatible to allow for support of both sets of offsets. The soft
core will not always have interrupts wired up, so only enforce them for
the "hard" core on PolarFire SoC.

Signed-off-by: Jamie Gibbons <jamie.gibbons at microchip.com>
Signed-off-by: Conor Dooley <conor.dooley at microchip.com>
---
 .../bindings/gpio/microchip,mpfs-gpio.yaml       | 16 +++++++++++++---
 1 file changed, 13 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/gpio/microchip,mpfs-gpio.yaml b/Documentation/devicetree/bindings/gpio/microchip,mpfs-gpio.yaml
index d481e78958a7..6884dacb2865 100644
--- a/Documentation/devicetree/bindings/gpio/microchip,mpfs-gpio.yaml
+++ b/Documentation/devicetree/bindings/gpio/microchip,mpfs-gpio.yaml
@@ -14,6 +14,7 @@ properties:
     items:
       - enum:
           - microchip,mpfs-gpio
+          - microchip,coregpio-rtl-v3
 
   reg:
     maxItems: 1
@@ -62,12 +63,21 @@ patternProperties:
       - gpio-hog
       - gpios
 
+allOf:
+  - if:
+      properties:
+        compatible:
+          contains:
+            const: microchip,mpfs-gpio
+    then:
+      required:
+        - interrupts
+        - "#interrupt-cells"
+        - interrupt-controller
+
 required:
   - compatible
   - reg
-  - interrupts
-  - "#interrupt-cells"
-  - interrupt-controller
   - "#gpio-cells"
   - gpio-controller
   - clocks
-- 
2.43.0