[PATCH v5 1/3] PCI: microchip: Fix outbound address translation tables

[daire.mcnamara at microchip.com]

From: Daire McNamara <daire.mcnamara at microchip.com>

On Microchip PolarFire SoC (MPFS) the PCIe Root Port can be behind one of
three general-purpose Fabric Interface Controller (FIC) buses that
encapsulate an AXI-M interface. That FIC is responsible for managing
the translations of the upper 32-bits of the AXI-M address. On MPFS,
the Root Port driver needs to take account of that outbound address
translation done by the parent FIC bus before setting up its own
outbound address translation tables.  In all cases on MPFS,
the remaining outbound address translation tables are 32-bit only.

Limit the outbound address translation tables to 32-bit only.

This necessitates changing a size_t in mc_pcie_setup_window
to a resource_size_t to avoid a compile error on 32-bit platforms.

Fixes: 6f15a9c9f941 ("PCI: microchip: Add Microchip Polarfire PCIe controller driver")
Signed-off-by: Daire McNamara <daire.mcnamara at microchip.com>
---
 drivers/pci/controller/pcie-microchip-host.c | 12 +++++++-----
 1 file changed, 7 insertions(+), 5 deletions(-)

diff --git a/drivers/pci/controller/pcie-microchip-host.c b/drivers/pci/controller/pcie-microchip-host.c
index 137fb8570ba2..47c397ae515a 100644
--- a/drivers/pci/controller/pcie-microchip-host.c
+++ b/drivers/pci/controller/pcie-microchip-host.c
@@ -23,6 +23,8 @@
 /* Number of MSI IRQs */
 #define MC_MAX_NUM_MSI_IRQS			32
 
+#define MC_OUTBOUND_TRANS_TBL_MASK		GENMASK(31, 0)
+
 /* PCIe Bridge Phy and Controller Phy offsets */
 #define MC_PCIE1_BRIDGE_ADDR			0x00008000u
 #define MC_PCIE1_CTRL_ADDR			0x0000a000u
@@ -933,7 +935,7 @@ static int mc_pcie_init_irq_domains(struct mc_pcie *port)
 
 static void mc_pcie_setup_window(void __iomem *bridge_base_addr, u32 index,
 				 phys_addr_t axi_addr, phys_addr_t pci_addr,
-				 size_t size)
+				 resource_size_t size)
 {
 	u32 atr_sz = ilog2(size) - 1;
 	u32 val;
@@ -983,7 +985,8 @@ static int mc_pcie_setup_windows(struct platform_device *pdev,
 		if (resource_type(entry->res) == IORESOURCE_MEM) {
 			pci_addr = entry->res->start - entry->offset;
 			mc_pcie_setup_window(bridge_base_addr, index,
-					     entry->res->start, pci_addr,
+					     entry->res->start & MC_OUTBOUND_TRANS_TBL_MASK,
+					     pci_addr,
 					     resource_size(entry->res));
 			index++;
 		}
@@ -1117,9 +1120,8 @@ static int mc_platform_init(struct pci_config_window *cfg)
 	int ret;
 
 	/* Configure address translation table 0 for PCIe config space */
-	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start,
-			     cfg->res.start,
-			     resource_size(&cfg->res));
+	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start & MC_OUTBOUND_TRANS_TBL_MASK,
+			     0, resource_size(&cfg->res));
 
 	/* Need some fixups in config space */
 	mc_pcie_enable_msi(port, cfg->win);
-- 
2.34.1