[PATCH v2 1/7] dt-bindings: clock: Document T-Head TH1520 AP_SUBSYS controller
Icenowy Zheng
uwu at icenowy.me
Fri Jul 26 22:21:39 PDT 2024
在 2024-07-26星期五的 09:38 -0700,Drew Fustini写道:
> On Fri, Jul 26, 2024 at 03:45:36AM -0500, Emil Renner Berthing wrote:
> > Stephen Boyd wrote:
> > > Quoting Drew Fustini (2024-06-23 19:12:31)
> > > > Document bindings for the T-Head TH1520 AP sub-system clock
> > > > controller.
> > > >
> > > > Link:
> > > > https://openbeagle.org/beaglev-ahead/beaglev-ahead/-/blob/main/docs/TH1520%20System%20User%20Manual.pdf
> > > > Co-developed-by: Yangtao Li <frank.li at vivo.com>
> > > > Signed-off-by: Yangtao Li <frank.li at vivo.com>
> > > > Reviewed-by: Conor Dooley <conor.dooley at microchip.com>
> > > > Signed-off-by: Drew Fustini <dfustini at tenstorrent.com>
> > > > ---
> > >
> > > Applied to clk-next
> >
> > Thanks, but this driver seems a bit incomplete. With this applied
> > the Lichee Pi
> > 4A no longer boots without the clk_ignore_unused kernel parameter.
> >
> > /Emil
>
> Is this the case when you apply the dts patches from this series?
>
> The dts patches won't go in until 6.12 so I don't think the presence
> of
> the clk-th1520-ap.c itself in 6.11 would break existing systems.
>
> That said, I have been using clk_ignore_unused. I had been thinking
> that
> made sense because the full set of clock controller drivers like
> AON_SUBSYS (always on), AUDIO_SUBSYS, DSP_SUBSYS, etc, are not
> present
> yet in mainline. However, the T-Head vendor kernel does have drivers
> for
> all those clock controllers and I was suprised to see that the vendor
> kernel fails to boot when I just tested removing clk_ignore_unused.
>
> As for clk-th1520-ap.c in mainline, I'll investigate further which
> clk
> disables seem to causing the boot failure when using the dts from
> this
> series. I suspect I may need to add nodes that will cause the
> necessary
> clks to be enabled by their respective drivers.
If disabling the clock just leads to system hang, setting
CLK_IS_CRITICAL should be useful (and needed) here.
>
> Thanks,
> Drew
>
> _______________________________________________
> linux-riscv mailing list
> linux-riscv at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-riscv
More information about the linux-riscv
mailing list