[PATCH v3 6/6] riscv: dts: starfive: add Milkv Mars board device tree
Jisheng Zhang
jszhang at kernel.org
Wed Jan 31 05:26:00 PST 2024
The Milkv Mars is a development board based on the Starfive JH7110 SoC.
The board features:
- JH7110 SoC
- 1/2/4/8 GiB LPDDR4 DRAM
- AXP15060 PMIC
- 40 pin GPIO header
- 3x USB 3.0 host port
- 1x USB 2.0 host port
- 1x M.2 E-Key
- 1x eMMC slot
- 1x MicroSD slot
- 1x QSPI Flash
- 1x 1Gbps Ethernet port
- 1x HDMI port
- 1x 2-lane DSI and 1x 4-lane DSI
- 1x 2-lane CSI
Add the devicetree file describing the currently supported features,
namely PMIC, UART, I2C, GPIO, SD card, QSPI Flash, eMMC and Ethernet.
Signed-off-by: Jisheng Zhang <jszhang at kernel.org>
---
arch/riscv/boot/dts/starfive/Makefile | 1 +
.../boot/dts/starfive/jh7110-milkv-mars.dts | 35 +++++++++++++++++++
2 files changed, 36 insertions(+)
create mode 100644 arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
diff --git a/arch/riscv/boot/dts/starfive/Makefile b/arch/riscv/boot/dts/starfive/Makefile
index 0141504c0f5c..2fa0cd7f31c3 100644
--- a/arch/riscv/boot/dts/starfive/Makefile
+++ b/arch/riscv/boot/dts/starfive/Makefile
@@ -8,5 +8,6 @@ DTC_FLAGS_jh7110-starfive-visionfive-2-v1.3b := -@
dtb-$(CONFIG_ARCH_STARFIVE) += jh7100-beaglev-starlight.dtb
dtb-$(CONFIG_ARCH_STARFIVE) += jh7100-starfive-visionfive-v1.dtb
+dtb-$(CONFIG_ARCH_STARFIVE) += jh7110-milkv-mars.dtb
dtb-$(CONFIG_ARCH_STARFIVE) += jh7110-starfive-visionfive-2-v1.2a.dtb
dtb-$(CONFIG_ARCH_STARFIVE) += jh7110-starfive-visionfive-2-v1.3b.dtb
diff --git a/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts b/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
new file mode 100644
index 000000000000..de600e799e7d
--- /dev/null
+++ b/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
@@ -0,0 +1,35 @@
+// SPDX-License-Identifier: GPL-2.0 OR MIT
+/*
+ * Copyright (C) 2023 Jisheng Zhang <jszhang at kernel.org>
+ */
+
+/dts-v1/;
+#include "jh7110-visionfive2-mars-common.dtsi"
+
+/ {
+ model = "Milk-V Mars";
+ compatible = "milkv,mars", "starfive,jh7110";
+};
+
+&gmac0 {
+ starfive,tx-use-rgmii-clk;
+ assigned-clocks = <&aoncrg JH7110_AONCLK_GMAC0_TX>;
+ assigned-clock-parents = <&aoncrg JH7110_AONCLK_GMAC0_RMII_RTX>;
+};
+
+
+&phy0 {
+ motorcomm,tx-clk-adj-enabled;
+ motorcomm,tx-clk-10-inverted;
+ motorcomm,tx-clk-100-inverted;
+ motorcomm,tx-clk-1000-inverted;
+ motorcomm,rx-clk-drv-microamp = <3970>;
+ motorcomm,rx-data-drv-microamp = <2910>;
+ rx-internal-delay-ps = <1500>;
+ tx-internal-delay-ps = <1500>;
+};
+
+&mmc1 {
+ disable-wp;
+ cd-gpios = <&sysgpio 41 GPIO_ACTIVE_LOW>;
+};
--
2.43.0
More information about the linux-riscv
mailing list