[RFC PATCH v2 4/6] pinctrl: starfive: jh8100: add pinctrl driver for sys_gmac domain
Alex Soo
yuklin.soo at starfivetech.com
Mon Feb 19 22:42:44 PST 2024
Add pinctrl driver for sys_gmac domain.
Signed-off-by: Alex Soo <yuklin.soo at starfivetech.com>
---
drivers/pinctrl/starfive/Kconfig | 12 +++
drivers/pinctrl/starfive/Makefile | 1 +
.../pinctrl-starfive-jh8100-sys-gmac.c | 93 +++++++++++++++++++
.../starfive/pinctrl-starfive-jh8100.h | 3 +
4 files changed, 109 insertions(+)
create mode 100644 drivers/pinctrl/starfive/pinctrl-starfive-jh8100-sys-gmac.c
diff --git a/drivers/pinctrl/starfive/Kconfig b/drivers/pinctrl/starfive/Kconfig
index d78f161a636c..bc123c0bf35e 100644
--- a/drivers/pinctrl/starfive/Kconfig
+++ b/drivers/pinctrl/starfive/Kconfig
@@ -82,3 +82,15 @@ config PINCTRL_STARFIVE_JH8100_SYS_WEST
This also provides an interface to the GPIO pins not used by other
peripherals supporting inputs, outputs, configuring pull-up/pull-down
and interrupts on input changes.
+
+config PINCTRL_STARFIVE_JH8100_SYS_GMAC
+ tristate "StarFive JH8100 SoC System IOMUX-GMAC pinctrl and GPIO driver"
+ depends on ARCH_STARFIVE || COMPILE_TEST
+ depends on OF
+ select PINCTRL_STARFIVE_JH8100
+ default ARCH_STARFIVE
+ help
+ Say yes here to support system iomux-gmac pin control on the StarFive JH8100 SoC.
+ This provides syscon registers to indicate voltage level on SDIO1/GMAC1, to indicate
+ GMAC1 pads voltage level under different GMAC interface modes, and to configure
+ GMAC1 interface slew rate.
diff --git a/drivers/pinctrl/starfive/Makefile b/drivers/pinctrl/starfive/Makefile
index 784465157ae2..236a693a8aef 100644
--- a/drivers/pinctrl/starfive/Makefile
+++ b/drivers/pinctrl/starfive/Makefile
@@ -9,3 +9,4 @@ obj-$(CONFIG_PINCTRL_STARFIVE_JH7110_AON) += pinctrl-starfive-jh7110-aon.o
obj-$(CONFIG_PINCTRL_STARFIVE_JH8100) += pinctrl-starfive-jh8100.o
obj-$(CONFIG_PINCTRL_STARFIVE_JH8100_SYS_EAST) += pinctrl-starfive-jh8100-sys-east.o
obj-$(CONFIG_PINCTRL_STARFIVE_JH8100_SYS_WEST) += pinctrl-starfive-jh8100-sys-west.o
+obj-$(CONFIG_PINCTRL_STARFIVE_JH8100_SYS_GMAC) += pinctrl-starfive-jh8100-sys-gmac.o
diff --git a/drivers/pinctrl/starfive/pinctrl-starfive-jh8100-sys-gmac.c b/drivers/pinctrl/starfive/pinctrl-starfive-jh8100-sys-gmac.c
new file mode 100644
index 000000000000..be0d238be08c
--- /dev/null
+++ b/drivers/pinctrl/starfive/pinctrl-starfive-jh8100-sys-gmac.c
@@ -0,0 +1,93 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/*
+ * Pinctrl / GPIO driver for StarFive JH8100 SoC sys gmac controller
+ *
+ * Copyright (C) 2023-2024 StarFive Technology Co., Ltd.
+ * Author: Alex Soo <yuklin.soo at starfivetech.com>
+ *
+ */
+
+#include <linux/gpio/driver.h>
+#include <linux/module.h>
+#include <linux/pinctrl/pinctrl.h>
+#include <linux/platform_device.h>
+#include <linux/pm_runtime.h>
+
+#include <dt-bindings/pinctrl/starfive,jh8100-pinctrl.h>
+
+#include "../core.h"
+#include "../pinmux.h"
+#include "../pinconf.h"
+#include "pinctrl-starfive-jh8100.h"
+
+#define JH8100_SYS_G_NGPIO 0
+#define JH8100_SYS_G_GC_BASE -1
+#define JH8100_SYS_G_DOMAIN_NAME "jh8100-sys-gmac"
+
+#ifdef CONFIG_PM_SLEEP
+static int jh8100_sys_gmac_pinctrl_suspend(struct device *dev)
+{
+ struct jh8100_pinctrl *sfp;
+ int i;
+
+ sfp = dev_get_drvdata(dev);
+ if (!sfp)
+ return -EINVAL;
+
+ for (i = 0; i < sfp->info->nregs; i++)
+ sfp->jh8100_sys_gmac_regs[i] = readl_relaxed(sfp->base + (i * 4));
+
+ return pinctrl_force_sleep(sfp->pctl);
+}
+
+static int jh8100_sys_gmac_pinctrl_resume(struct device *dev)
+{
+ struct jh8100_pinctrl *sfp;
+ int i;
+
+ sfp = dev_get_drvdata(dev);
+ if (!sfp)
+ return -EINVAL;
+
+ for (i = 0; i < sfp->info->nregs; i++)
+ writel_relaxed(sfp->jh8100_sys_gmac_regs[i], sfp->base + (i * 4));
+
+ return pinctrl_force_default(sfp->pctl);
+}
+#endif
+
+static SIMPLE_DEV_PM_OPS(jh8100_sys_gmac_pinctrl_dev_pm_ops,
+ jh8100_sys_gmac_pinctrl_suspend,
+ jh8100_sys_gmac_pinctrl_resume);
+
+static const struct jh8100_pinctrl_domain_info jh8100_sys_gmac_pinctrl_info = {
+ .ngpios = JH8100_SYS_G_NGPIO,
+ .gc_base = JH8100_SYS_G_GC_BASE,
+ .name = JH8100_SYS_G_DOMAIN_NAME,
+ .nregs = JH8100_SYS_G_REG_NUM,
+};
+
+static const struct of_device_id jh8100_sys_gmac_pinctrl_of_match[] = {
+ {
+ .compatible = "starfive,jh8100-sys-pinctrl-gmac",
+ .data = &jh8100_sys_gmac_pinctrl_info,
+ },
+ { /* sentinel */ }
+};
+MODULE_DEVICE_TABLE(of, jh8100_sys_gmac_pinctrl_of_match);
+
+static struct platform_driver jh8100_sys_gmac_pinctrl_driver = {
+ .probe = jh8100_pinctrl_probe,
+ .driver = {
+ .name = "starfive-jh8100-sys-pinctrl-gmac",
+#ifdef CONFIG_PM_SLEEP
+ .pm = &jh8100_sys_gmac_pinctrl_dev_pm_ops,
+#endif
+ .of_match_table = jh8100_sys_gmac_pinctrl_of_match,
+ },
+};
+module_platform_driver(jh8100_sys_gmac_pinctrl_driver);
+
+MODULE_DESCRIPTION("Pinctrl driver for StarFive JH8100 SoC sys gmac controller");
+MODULE_AUTHOR("Alex Soo <yuklin.soo at starfivetech.com>");
+MODULE_LICENSE("GPL v2");
diff --git a/drivers/pinctrl/starfive/pinctrl-starfive-jh8100.h b/drivers/pinctrl/starfive/pinctrl-starfive-jh8100.h
index 92d3b5d6de40..4652885feaa2 100644
--- a/drivers/pinctrl/starfive/pinctrl-starfive-jh8100.h
+++ b/drivers/pinctrl/starfive/pinctrl-starfive-jh8100.h
@@ -15,9 +15,11 @@
#define JH8100_SYS_W_DOMAIN_NAME "jh8100-sys-west"
#define JH8100_SYS_E_DOMAIN_NAME "jh8100-sys-east"
+#define JH8100_SYS_G_DOMAIN_NAME "jh8100-sys-gmac"
#define JH8100_SYS_W_REG_NUM 44
#define JH8100_SYS_E_REG_NUM 116
+#define JH8100_SYS_G_REG_NUM 19
#define JH8100_SYS_W_GPO_PDA_00_15_CFG 0x074
#define JH8100_SYS_E_GPO_PDA_00_47_CFG 0x114
@@ -34,6 +36,7 @@ struct jh8100_pinctrl {
const struct jh8100_pinctrl_domain_info *info;
unsigned int jh8100_sys_west_regs[JH8100_SYS_W_REG_NUM];
unsigned int jh8100_sys_east_regs[JH8100_SYS_E_REG_NUM];
+ unsigned int jh8100_sys_gmac_regs[JH8100_SYS_G_REG_NUM];
/* wakeup */
int wakeup_gpio;
int wakeup_irq;
--
2.43.0
More information about the linux-riscv
mailing list