[PATCH] riscv: Fix linear mapping checks for non-contiguous memory regions
Alexandre Ghiti
alex at ghiti.fr
Mon Aug 26 04:26:25 PDT 2024
Hi Geert,
On 20/08/2024 15:32, Geert Uytterhoeven wrote:
> Hi Stuart,
>
> On Sat, Jun 22, 2024 at 1:43 PM Stuart Menefy <stuart.menefy at codasip.com> wrote:
>> The RISC-V kernel already has checks to ensure that memory which would
>> lie outside of the linear mapping is not used. However those checks
>> use memory_limit, which is used to implement the mem= kernel command
>> line option (to limit the total amount of memory, not its address
>> range). When memory is made up of two or more non-contiguous memory
>> banks this check is incorrect.
>>
>> Two changes are made here:
>> - add a call in setup_bootmem() to memblock_cap_memory_range() which
>> will cause any memory which falls outside the linear mapping to be
>> removed from the memory regions.
>> - remove the check in create_linear_mapping_page_table() which was
>> intended to remove memory which is outside the liner mapping based
>> on memory_limit, as it is no longer needed. Note a check for
>> mapping more memory than memory_limit (to implement mem=) is
>> unnecessary because of the existing call to
>> memblock_enforce_memory_limit().
>>
>> This issue was seen when booting on a SV39 platform with two memory
>> banks:
>> 0x00,80000000 1GiB
>> 0x20,00000000 32GiB
>> This memory range is 158GiB from top to bottom, but the linear mapping
>> is limited to 128GiB, so the lower block of RAM will be mapped at
>> PAGE_OFFSET, and the upper block straddles the top of the linear
>> mapping.
>>
>> This causes the following Oops:
>> [ 0.000000] Linux version 6.10.0-rc2-gd3b8dd5b51dd-dirty (stuart.menefy at codasip.com) (riscv64-codasip-linux-gcc (GCC) 13.2.0, GNU ld (GNU Binutils) 2.41.0.20231213) #20 SMP Sat Jun 22 11:34:22 BST 2024
>> [ 0.000000] memblock_add: [0x0000000080000000-0x00000000bfffffff] early_init_dt_add_memory_arch+0x4a/0x52
>> [ 0.000000] memblock_add: [0x0000002000000000-0x00000027ffffffff] early_init_dt_add_memory_arch+0x4a/0x52
>> ...
>> [ 0.000000] memblock_alloc_try_nid: 23724 bytes align=0x8 nid=-1 from=0x0000000000000000 max_addr=0x0000000000000000 early_init_dt_alloc_memory_arch+0x1e/0x48
>> [ 0.000000] memblock_reserve: [0x00000027ffff5350-0x00000027ffffaffb] memblock_alloc_range_nid+0xb8/0x132
>> [ 0.000000] Unable to handle kernel paging request at virtual address fffffffe7fff5350
>> [ 0.000000] Oops [#1]
>> [ 0.000000] Modules linked in:
>> [ 0.000000] CPU: 0 PID: 0 Comm: swapper Not tainted 6.10.0-rc2-gd3b8dd5b51dd-dirty #20
>> [ 0.000000] Hardware name: codasip,a70x (DT)
>> [ 0.000000] epc : __memset+0x8c/0x104
>> [ 0.000000] ra : memblock_alloc_try_nid+0x74/0x84
>> [ 0.000000] epc : ffffffff805e88c8 ra : ffffffff806148f6 sp : ffffffff80e03d50
>> [ 0.000000] gp : ffffffff80ec4158 tp : ffffffff80e0bec0 t0 : fffffffe7fff52f8
>> [ 0.000000] t1 : 00000027ffffb000 t2 : 5f6b636f6c626d65 s0 : ffffffff80e03d90
>> [ 0.000000] s1 : 0000000000005cac a0 : fffffffe7fff5350 a1 : 0000000000000000
>> [ 0.000000] a2 : 0000000000005cac a3 : fffffffe7fffaff8 a4 : 000000000000002c
>> [ 0.000000] a5 : ffffffff805e88c8 a6 : 0000000000005cac a7 : 0000000000000030
>> [ 0.000000] s2 : fffffffe7fff5350 s3 : ffffffffffffffff s4 : 0000000000000000
>> [ 0.000000] s5 : ffffffff8062347e s6 : 0000000000000000 s7 : 0000000000000001
>> [ 0.000000] s8 : 0000000000002000 s9 : 00000000800226d0 s10: 0000000000000000
>> [ 0.000000] s11: 0000000000000000 t3 : ffffffff8080a928 t4 : ffffffff8080a928
>> [ 0.000000] t5 : ffffffff8080a928 t6 : ffffffff8080a940
>> [ 0.000000] status: 0000000200000100 badaddr: fffffffe7fff5350 cause: 000000000000000f
>> [ 0.000000] [<ffffffff805e88c8>] __memset+0x8c/0x104
>> [ 0.000000] [<ffffffff8062349c>] early_init_dt_alloc_memory_arch+0x1e/0x48
>> [ 0.000000] [<ffffffff8043e892>] __unflatten_device_tree+0x52/0x114
>> [ 0.000000] [<ffffffff8062441e>] unflatten_device_tree+0x9e/0xb8
>> [ 0.000000] [<ffffffff806046fe>] setup_arch+0xd4/0x5bc
>> [ 0.000000] [<ffffffff806007aa>] start_kernel+0x76/0x81a
>> [ 0.000000] Code: b823 02b2 bc23 02b2 b023 04b2 b423 04b2 b823 04b2 (bc23) 04b2
>> [ 0.000000] ---[ end trace 0000000000000000 ]---
>> [ 0.000000] Kernel panic - not syncing: Attempted to kill the idle task!
>> [ 0.000000] ---[ end Kernel panic - not syncing: Attempted to kill the idle task! ]---
>>
>> The problem is that memblock (unaware that some physical memory cannot
>> be used) has allocated memory from the top of memory but which is
>> outside the linear mapping region.
>>
>> Signed-off-by: Stuart Menefy <stuart.menefy at codasip.com>
>> Fixes: c99127c45248 ("riscv: Make sure the linear mapping does not use the kernel mapping")
>> Reviewed-by: David McKay <david.mckay at codasip.com>
> Thanks for your patch, which is now commit 3b6564427aea83b7 ("riscv:
> Fix linear mapping checks for non-contiguous memory regions") in
> v6.11-rc2.
>
> This causes the boot to hang on SiPEED MAiX BiT (K210 64-bit nommu):
>
> Linux version 6.11.0-rc1-k210-00008-g3b6564427aea (geert at rox)
> (riscv64-linux-gnu-gcc (Ubuntu 11.4.0-1ubuntu1~22.04) 11.4.0, GNU ld
> (GNU Binutils for Ubuntu) 2.38) #452 SMP Tue Aug 20 15:02:49 CEST 2024
> Machine model: SiPeed MAIX BiT
> Forcing kernel command line to: earlycon console=ttySIF0 rootdelay=2
> root=/dev/mmcblk0p1 ro
> earlycon: sifive0 at MMIO 0x0000000038000000 (options '115200n8')
> printk: legacy bootconsole [sifive0] enabled
> Zone ranges:
> DMA32 [mem 0x0000000080000000-0x00000000807fffff]
> Normal empty
> Movable zone start for each node
> Early memory node ranges
> node 0: [mem 0x0000000080000000-0x00000000807fffff]
> Initmem setup node 0 [mem 0x0000000080000000-0x00000000807fffff]
> Falling back to deprecated "riscv,isa"
> riscv: base ISA extensions acdfim
> riscv: ELF capabilities acdfim
> percpu: max_distance=0x1a000 too large for vmalloc space 0x0
> percpu: Embedded 13 pages/cpu s20512 r0 d32736 u53248
> percpu: wasting 6 pages per chunk
> Kernel command line: earlycon console=ttySIF0 rootdelay=2 root=/dev/mmcblk0p1 ro
> Dentry cache hash table entries: 1024 (order: 1, 8192 bytes, linear)
> Inode-cache hash table entries: 512 (order: 0, 4096 bytes, linear)
> Built 1 zonelists, mobility grouping off. Total pages: 2048
> mem auto-init: stack:off, heap alloc:off, heap free:off
> SLUB: HWalign=64, Order=0-1, MinObjects=0, CPUs=2, Nodes=1
> rcu: Hierarchical RCU implementation.
> rcu: RCU calculated value of scheduler-enlistment delay is 25 jiffies.
> NR_IRQS: 64, nr_irqs: 64, preallocated irqs: 0
>
> Adding a bit of debug info shows:
>
> setup_bootmem:236: old phys_ram_end = 0x80800000
> setup_bootmem:258: max_mapped_addr = 0x7fffffff
> setup_bootmem:259: memblock_cap_memory_range(0x80000000, 0xffffffffffffffff)
> memblock_remove_range:857: Removing region at 0x80000000 size 0x20d1e8
> setup_bootmem:281: new phys_ram_end = 0x80800000
Thank you very much for the report!
The following patch should fix this, can you give it a try?
diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
index eb0649a61b4c..1785782c2e55 100644
--- a/arch/riscv/mm/init.c
+++ b/arch/riscv/mm/init.c
@@ -252,7 +252,7 @@ static void __init setup_bootmem(void)
* The size of the linear page mapping may restrict the amount of
* usable RAM.
*/
- if (IS_ENABLED(CONFIG_64BIT)) {
+ if (IS_ENABLED(CONFIG_64BIT) && IS_ENABLED(CONFIG_MMU)) {
max_mapped_addr = __pa(PAGE_OFFSET) + KERN_VIRT_SIZE;
memblock_cap_memory_range(phys_ram_base,
max_mapped_addr - phys_ram_base);
It makes no sense to restrict physical memory size because of linear
mapping size constraints when there is no linear mapping :)
I'll send a proper patch when you confirm it works for you :)
Thanks again,
Alex
>> --- a/arch/riscv/mm/init.c
>> +++ b/arch/riscv/mm/init.c
>> @@ -233,8 +233,6 @@ static void __init setup_bootmem(void)
>> */
>> memblock_reserve(vmlinux_start, vmlinux_end - vmlinux_start);
>>
>> - phys_ram_end = memblock_end_of_DRAM();
>> -
>> /*
>> * Make sure we align the start of the memory on a PMD boundary so that
>> * at worst, we map the linear mapping with PMD mappings.
>> @@ -249,6 +247,16 @@ static void __init setup_bootmem(void)
>> if (IS_ENABLED(CONFIG_64BIT) && IS_ENABLED(CONFIG_MMU))
>> kernel_map.va_pa_offset = PAGE_OFFSET - phys_ram_base;
>>
>> + /*
>> + * The size of the linear page mapping may restrict the amount of
>> + * usable RAM.
>> + */
>> + if (IS_ENABLED(CONFIG_64BIT)) {
>> + max_mapped_addr = __pa(PAGE_OFFSET) + KERN_VIRT_SIZE;
>> + memblock_cap_memory_range(phys_ram_base,
>> + max_mapped_addr - phys_ram_base);
>> + }
>> +
>> /*
>> * Reserve physical address space that would be mapped to virtual
>> * addresses greater than (void *)(-PAGE_SIZE) because:
>> @@ -265,6 +273,7 @@ static void __init setup_bootmem(void)
>> memblock_reserve(max_mapped_addr, (phys_addr_t)-max_mapped_addr);
>> }
>>
>> + phys_ram_end = memblock_end_of_DRAM();
>> min_low_pfn = PFN_UP(phys_ram_base);
>> max_low_pfn = max_pfn = PFN_DOWN(phys_ram_end);
>> high_memory = (void *)(__va(PFN_PHYS(max_low_pfn)));
>> @@ -1289,8 +1298,6 @@ static void __init create_linear_mapping_page_table(void)
>> if (start <= __pa(PAGE_OFFSET) &&
>> __pa(PAGE_OFFSET) < end)
>> start = __pa(PAGE_OFFSET);
>> - if (end >= __pa(PAGE_OFFSET) + memory_limit)
>> - end = __pa(PAGE_OFFSET) + memory_limit;
>>
>> create_linear_mapping_range(start, end, 0);
>> }
> Gr{oetje,eeting}s,
>
> Geert
>
More information about the linux-riscv
mailing list