[PATCH v1 0/5] PolarFire SoC Auto Update design info support

[Conor Dooley]

From: Conor Dooley <conor.dooley at microchip.com>

There's a document that is internally available that the author of the
design info/overlay format stuff wrote about how it is composed and I
need to go read it and make a version of it publicly available before
this can be merged.

While implementing the design info support, I found a few opportunities
for cleaning up the code and fixed a bug that had been mentioned
internally about failure cases printing success. The scope based cleanup
stuff in particular is rather helpful for the drivers using the system
services mailbox, so I'll roll that out to the other users soonTM.

CC: Conor Dooley <conor.dooley at microchip.com>
CC: Daire McNamara <daire.mcnamara at microchip.com>
CC: Cyril Jean <cyril.jean at microchip.com>
CC: linux-riscv at lists.infradead.org
CC: linux-kernel at vger.kernel.org

Conor Dooley (5):
  firmware: microchip: support writing bitstream info to flash
  firmware: microchip: don't unconditionally print validation success
  firmware: microchip: clarify that sizes and addresses are in hex
  firmware: microchip: move buffer allocation into
    mpfs_auto_update_set_image_address()
  firmware: microchip: use scope-based cleanup where possible

 drivers/firmware/microchip/mpfs-auto-update.c | 140 +++++++++---------
 1 file changed, 70 insertions(+), 70 deletions(-)

-- 
2.43.0