[PATCH v2 2/3] clocksource/drivers/timer-clint: Add option to use CSR instead of mtime
Jisheng Zhang
jszhang at kernel.org
Tue Apr 9 07:48:28 PDT 2024
On Tue, Apr 09, 2024 at 03:26:18PM +0100, Conor Dooley wrote:
> On Sat, Apr 06, 2024 at 07:21:58PM +0800, Jisheng Zhang wrote:
> > As pointed out by commit ca7810aecdba ("lib: utils/timer: mtimer: add a
> > quirk for lacking mtime register") of opensbi:
> >
> > "T-Head developers surely have a different understanding of time CSR and
> > CLINT's mtime register with SiFive ones, that they did not implement
> > the mtime register at all -- as shown in openC906 source code, their
> > time CSR value is just exposed at the top of their processor IP block
> > and expects an external continous counter, which makes it not
> > overrideable, and thus mtime register is not implemented, even not for
> > reading. However, if CLINTEE is not enabled in T-Head's MXSTATUS
> > extended CSR, these systems still rely on the mtimecmp registers to
> > generate timer interrupts. This makes it necessary to implement T-Head
> > C9xx CLINT support in OpenSBI MTIMER driver, which skips implementing
> > reading mtime register and falls back to default code that reads time
> > CSR."
> >
> > To use the clint in RISCV-M NOMMU env on Milkv Duo little core, we
> > need to fall back to read time CSR instead of mtime register. Add the
> > option for this purpose.
> >
> > Signed-off-by: Jisheng Zhang <jszhang at kernel.org>
>
> > diff --git a/drivers/clocksource/Kconfig b/drivers/clocksource/Kconfig
> > index 34faa0320ece..7bbdbf2f96a8 100644
> > --- a/drivers/clocksource/Kconfig
> > +++ b/drivers/clocksource/Kconfig
> > @@ -650,6 +650,15 @@ config CLINT_TIMER
> > This option enables the CLINT timer for RISC-V systems. The CLINT
> > driver is usually used for NoMMU RISC-V systems.
> >
> > +config CLINT_USE_CSR_INSTEADOF_MTIME
> > + bool "Use TIME CSR instead of the mtime register"
> > + depends on CLINT_TIMER
> > + help
> > + Use TIME CSR instead of mtime register. Enable this option if
> > + prefer TIME CSR over MTIME register, or if the implementation
> > + doesn't implement the mtime register in CLINT, so fall back on
> > + TIME CSR.
>
> This, as a Kconfig option, seems a bit strange to me. We know at runtime
> if we are on a T-Head device without the mtime register and should be
> able decide to use the CSR implementation dynamically in that case,
> right?
Dynamically decision can be done in clocksource/clockevnt:
I can patch clint_clocksource.read to point to different clint_rdtime()
implementation.
But clint timer is also used in NOMMU RISCV-M's get_cycles(), this
can't be dynamically chosen w/o an ugly "if (is_c900)"
check, and I'm not sure whether this check in get_cycles() will
introduce non-trival overhead or not. Or use code patching technology
here?
Or introduce a function pointer such as unsigned long (*rdtime)(void)
for RISCV_M_MODE, then point it to different implementation?
Any suggestion is welcome.
Thanks
More information about the linux-riscv
mailing list