[PATCH v7 4/4] RISC-V: Add arch functions to support hibernation/suspend-to-disk
Andrew Jones
ajones at ventanamicro.com
Mon Mar 27 06:22:51 PDT 2023
On Mon, Mar 27, 2023 at 03:10:25PM +0200, Andrew Jones wrote:
> On Thu, Mar 23, 2023 at 12:56:04PM +0800, Sia Jee Heng wrote:
> > Low level Arch functions were created to support hibernation.
> > swsusp_arch_suspend() relies code from __cpu_suspend_enter() to write
> > cpu state onto the stack, then calling swsusp_save() to save the memory
> > image.
> >
> > Arch specific hibernation header is implemented and is utilized by the
> > arch_hibernation_header_restore() and arch_hibernation_header_save()
> > functions. The arch specific hibernation header consists of satp, hartid,
> > and the cpu_resume address. The kernel built version is also need to be
> > saved into the hibernation image header to making sure only the same
> > kernel is restore when resume.
> >
> > swsusp_arch_resume() creates a temporary page table that covering only
> > the linear map. It copies the restore code to a 'safe' page, then start
> > to restore the memory image. Once completed, it restores the original
> > kernel's page table. It then calls into __hibernate_cpu_resume()
> > to restore the CPU context. Finally, it follows the normal hibernation
> > path back to the hibernation core.
> >
> > To enable hibernation/suspend to disk into RISCV, the below config
> > need to be enabled:
> > - CONFIG_ARCH_HIBERNATION_HEADER
> > - CONFIG_ARCH_HIBERNATION_POSSIBLE
> >
> > Signed-off-by: Sia Jee Heng <jeeheng.sia at starfivetech.com>
> > Reviewed-by: Ley Foon Tan <leyfoon.tan at starfivetech.com>
> > Reviewed-by: Mason Huo <mason.huo at starfivetech.com>
> > Reviewed-by: Conor Dooley <conor.dooley at microchip.com>
> > ---
> > arch/riscv/Kconfig | 6 +
> > arch/riscv/include/asm/assembler.h | 20 ++
> > arch/riscv/include/asm/suspend.h | 19 ++
> > arch/riscv/kernel/Makefile | 1 +
> > arch/riscv/kernel/asm-offsets.c | 5 +
> > arch/riscv/kernel/hibernate-asm.S | 77 ++++++
> > arch/riscv/kernel/hibernate.c | 427 +++++++++++++++++++++++++++++
> > 7 files changed, 555 insertions(+)
> > create mode 100644 arch/riscv/kernel/hibernate-asm.S
> > create mode 100644 arch/riscv/kernel/hibernate.c
> >
>
> Reviewed-by: Andrew Jones <ajones at ventanamicro.com>
Actually, I forgot to point out something. As hibernation depends on
suspend.c for save/restore_csrs, we need something like
diff --git a/arch/riscv/Kconfig b/arch/riscv/Kconfig
index 73cca7f17f6f..f1d2289df660 100644
--- a/arch/riscv/Kconfig
+++ b/arch/riscv/Kconfig
@@ -54,7 +54,7 @@ config RISCV
select CLINT_TIMER if !MMU
select CLONE_BACKWARDS
select COMMON_CLK
- select CPU_PM if CPU_IDLE
+ select CPU_PM if CPU_IDLE || HIBERNATION
select EDAC_SUPPORT
select GENERIC_ARCH_TOPOLOGY
select GENERIC_ATOMIC64 if !64BIT
Thanks,
drew
More information about the linux-riscv
mailing list