[PATCH v4 12/19] clk: starfive: Add StarFive JH7110 always-on clock driver

[Palmer Dabbelt]

On Thu, 09 Mar 2023 10:19:06 PST (-0800), emil.renner.berthing at canonical.com wrote:
> On Thu, 9 Mar 2023 at 19:11, Conor Dooley <conor at kernel.org> wrote:
>>
>> On Thu, Mar 09, 2023 at 03:06:13PM +0100, Emil Renner Berthing wrote:
>> >  On Thu, 9 Mar 2023 at 10:44, Hal Feng <hal.feng at starfivetech.com> wrote:
>>
>> > > The AON clock driver provides clocks for gmac0 which is used frequently.
>> > > So I think it would be more convenient if we set "default y" here.
>>
>> > You're right that if we default y for the ethernet driver then the aon
>> > clock/reset should also default y. Personally I don't think we should
>> > default y for every ethernet driver that might be used on some
>> > supported risc-v platform, but I see now that
>> > arch/riscv/config/defconfig already contains CONFIG_MACB=y,
>> > CONFIG_E1000E=y, CONFIG_R8169=y and CONFIG_MICROSEMI_PHY=y, so maybe
>> > I'm wrong or just too late.
>>
>> The defconfig really needs a good bit of cleanup (one of the many things
>> that I am telling myself I will do as part of kconfig.socs cleanup).
>>
>> w.r.t defconfig Palmer said it pretty well earlier on IRC: "defconfig
>> should be useful for kernel devs, which means it should boot on the
>> common dev boards".
>>
>> IMO, that means enough to boot an initramfs and poke the thing to see
>> that it is alive, so: ethernet & serial, and the clocks/resets/pinctrl
>> stuff required to get those going can all be set to y in defconfig.
>>
>> In the driver Kconfig entries, to me, it's more or less the same.
>> I guess, answer the question "Will your customer's board get to the
>> point where it can load a module ithout building this into the kernel?".
>> If the answer to that question is yes, then don't make it default y.
>>
>> That's my €0.02!
>
> Cool. Defaulting to m in the Kconfig for anything that can be loaded
> later is exactly what I was trying to say, except I mixed in the
> defconfig for no good reason. That means both the aon clocks and
> dwmac-starfive should default to m in Kconfig. The JH7110 (VisionFive
> 2) boots just fine like that and brings up aon clocks and ethernet
> after loading the modules.

That seems pretty reasonable to me.  It's not like defconfig or Kconfig 
defaults or whatever are the only things we're going to test, but it's 
way easier for folks trying poke around with these dev boards if they 
boot defconfig.