[PATCH] riscv: move memblock_allow_resize() after lm is ready

Alexandre Ghiti alexghiti at rivosinc.com
Mon Jun 12 00:15:38 PDT 2023


Hi Woody,

On Sat, Jun 10, 2023 at 1:49 AM Woody Zhang <woodylab at foxmail.com> wrote:
>
> The initial memblock metadata is accessed from kernel image mapping. The
> regions arrays need to "reallocated" from memblock and accessed through
> linear mapping to cover more memblock regions. So the resizing should
> not be allowed until linear mapping is ready. Note that there are
> memblock allocations when building linear mapping.
>
> Signed-off-by: Woody Zhang <woodylab at foxmail.com>
> ---
>  arch/riscv/mm/init.c | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
> index 9e9da69720ce..8a33ecbb4d0f 100644
> --- a/arch/riscv/mm/init.c
> +++ b/arch/riscv/mm/init.c
> @@ -258,7 +258,6 @@ static void __init setup_bootmem(void)
>         dma_contiguous_reserve(dma32_phys_limit);
>         if (IS_ENABLED(CONFIG_64BIT))
>                 hugetlb_cma_reserve(PUD_SHIFT - PAGE_SHIFT);
> -       memblock_allow_resize();
>  }
>
>  #ifdef CONFIG_MMU
> @@ -1250,6 +1249,9 @@ static void __init setup_vm_final(void)
>         csr_write(CSR_SATP, PFN_DOWN(__pa_symbol(swapper_pg_dir)) | satp_mode);
>         local_flush_tlb_all();
>
> +       /* Depend on that Linear Mapping is ready */
> +       memblock_allow_resize();
> +
>         pt_ops_set_late();
>  }
>  #else
> --
> 2.39.2
>

The commit log does not describe the issue thoroughly enough to me,
maybe you could point to the arm64 commit that did the same? I mean
commit 24cc61d8cb5a ("arm64: memblock: don't permit memblock resizing
until linear mapping is up").

Another point is that I would not put this call into setup_vm_final(),
I'd rather add it in paging_init() as it does not seem like a good fit
for setup_vm_final(). But that's a nit so up to you of course.

Anyway, that's a good catch, thanks!

Alex



More information about the linux-riscv mailing list