[PATCH] riscv: move memblock_allow_resize() after lm is ready

[Woody Zhang]

The initial memblock metadata is accessed from kernel image mapping. The
regions arrays need to "reallocated" from memblock and accessed through
linear mapping to cover more memblock regions. So the resizing should
not be allowed until linear mapping is ready. Note that there are
memblock allocations when building linear mapping.

Signed-off-by: Woody Zhang <woodylab at foxmail.com>
---
 arch/riscv/mm/init.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
index 9e9da69720ce..8a33ecbb4d0f 100644
--- a/arch/riscv/mm/init.c
+++ b/arch/riscv/mm/init.c
@@ -258,7 +258,6 @@ static void __init setup_bootmem(void)
 	dma_contiguous_reserve(dma32_phys_limit);
 	if (IS_ENABLED(CONFIG_64BIT))
 		hugetlb_cma_reserve(PUD_SHIFT - PAGE_SHIFT);
-	memblock_allow_resize();
 }
 
 #ifdef CONFIG_MMU
@@ -1250,6 +1249,9 @@ static void __init setup_vm_final(void)
 	csr_write(CSR_SATP, PFN_DOWN(__pa_symbol(swapper_pg_dir)) | satp_mode);
 	local_flush_tlb_all();
 
+	/* Depend on that Linear Mapping is ready */
+	memblock_allow_resize();
+
 	pt_ops_set_late();
 }
 #else
-- 
2.39.2