[PATCH v3 0/3] StarFive's SDIO/eMMC driver support

Emil Renner Berthing emil.renner.berthing at canonical.com
Wed Feb 15 02:00:46 PST 2023


On Tue, 14 Feb 2023 at 13:21, Ulf Hansson <ulf.hansson at linaro.org> wrote:
>
> On Fri, 3 Feb 2023 at 09:19, William Qiu <william.qiu at starfivetech.com> wrote:
> >
> > Hi,
> >
> > This patchset adds initial rudimentary support for the StarFive
> > designware mobile storage host controller driver. And this driver will
> > be used in StarFive's VisionFive 2 board. The main purpose of adding
> > this driver is to accommodate the ultra-high speed mode of eMMC.
> >
> > The last patch should be applied after the patchset [1]:
> > [1] https://lore.kernel.org/all/20221220011247.35560-1-hal.feng@starfivetech.com/
> >
> > Changes since v2:
> > - Wraped commit message according to Linux coding style.
> > - Rephrased the description of the patches.
> > - Changed the description of syscon regsiter.
> > - Dropped redundant properties.
> >
> > The patch series is based on v6.1.
> >
> > William Qiu (3):
> >   dt-bindings: mmc: Add StarFive MMC module
> >   mmc: starfive: Add sdio/emmc driver support
> >   riscv: dts: starfive: Add mmc node
> >
> >  .../bindings/mmc/starfive,jh7110-mmc.yaml     |  77 ++++++++
> >  MAINTAINERS                                   |   6 +
> >  .../jh7110-starfive-visionfive-2.dtsi         |  23 +++
> >  arch/riscv/boot/dts/starfive/jh7110.dtsi      |  37 ++++
> >  drivers/mmc/host/Kconfig                      |  10 +
> >  drivers/mmc/host/Makefile                     |   1 +
> >  drivers/mmc/host/dw_mmc-starfive.c            | 185 ++++++++++++++++++
> >  7 files changed, 339 insertions(+)
> >  create mode 100644 Documentation/devicetree/bindings/mmc/starfive,jh7110-mmc.yaml
> >  create mode 100644 drivers/mmc/host/dw_mmc-starfive.c
> >
>
> Patch 1 and patch 2 applied for next, thanks!
>
> Note that I fixed some checkpatch errors/warnings. Next time, please
> run ./scripts/checkpatch.pl before you submit your patches.

Hi,

Something here is not right. The bindings document "starfive,sysreg",
but the code is looking for "starfive,syscon".
William, did you test this and run dtbs_check before sending this series?

/Emil

> Kind regards
> Uffe
>
> _______________________________________________
> linux-riscv mailing list
> linux-riscv at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-riscv



More information about the linux-riscv mailing list