[PATCH v13 19/21] PCI: Add PCIE_RESET_CONFIG_DEVICE_WAIT_MS waiting time value

[Bjorn Helgaas]

On Thu, Dec 14, 2023 at 03:28:37PM +0800, Minda Chen wrote:
> From: Kevin Xie <kevin.xie at starfivetech.com>
> 
> Add the PCIE_RESET_CONFIG_DEVICE_WAIT_MS macro to define the minimum
> waiting time between exit from a conventional reset and sending the
> first configuration request to the device.
> 
> As described in PCI base specification r6.0, section 6.6.1 <Conventional
> Reset>, there are two different use cases of the value:
> 
>    - "With a Downstream Port that does not support Link speeds greater
>      than 5.0 GT/s, software must wait a minimum of 100 ms following exit
>      from a Conventional Reset before sending a Configuration Request to
>      the device immediately below that Port."
> 
>    - "With a Downstream Port that supports Link speeds greater than
>      5.0 GT/s, software must wait a minimum of 100 ms after Link training
>      completes before sending a Configuration Request to the device
>      immediately below that Port."
> 
> Signed-off-by: Kevin Xie <kevin.xie at starfivetech.com>
> Reviewed-by: Mason Huo <mason.huo at starfivetech.com>

Acked-by: Bjorn Helgaas <bhelgaas at google.com>

> ---
>  drivers/pci/pci.h | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
> index 5ecbcf041179..06f1f1eb878c 100644
> --- a/drivers/pci/pci.h
> +++ b/drivers/pci/pci.h
> @@ -22,6 +22,22 @@
>   */
>  #define PCIE_PME_TO_L2_TIMEOUT_US	10000
>  
> +/*
> + * As described in PCI base specification r6.0, section 6.6.1 <Conventional
> + * Reset>, there are two different use cases of the value:
> + *
> + * - "With a Downstream Port that does not support Link speeds greater
> + *    than 5.0 GT/s, software must wait a minimum of 100 ms following exit
> + *    from a Conventional Reset before sending a Configuration Request to
> + *    the device immediately below that Port."
> + *
> + * - "With a Downstream Port that supports Link speeds greater than
> + *    5.0 GT/s, software must wait a minimum of 100 ms after Link training
> + *    completes before sending a Configuration Request to the device
> + *    immediately below that Port."
> + */
> +#define PCIE_RESET_CONFIG_DEVICE_WAIT_MS	100
> +
>  extern const unsigned char pcie_link_speed[];
>  extern bool pci_early_dump;
>  
> -- 
> 2.17.1
>