[RFC 4/9] drivers/perf: riscv: Read upper bits of a firmware counter

[Atish Patra]

SBI v2.0 introduced a explicit function to read the upper bits
for any firmwar counter width that is longer than XLEN. Currently,
this is only applicable for RV32 where firmware counter can be
64 bit.

Signed-off-by: Atish Patra <atishp at rivosinc.com>
---
 drivers/perf/riscv_pmu_sbi.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/perf/riscv_pmu_sbi.c b/drivers/perf/riscv_pmu_sbi.c
index 40a335350d08..1c9049e6b574 100644
--- a/drivers/perf/riscv_pmu_sbi.c
+++ b/drivers/perf/riscv_pmu_sbi.c
@@ -490,16 +490,23 @@ static u64 pmu_sbi_ctr_read(struct perf_event *event)
 	struct hw_perf_event *hwc = &event->hw;
 	int idx = hwc->idx;
 	struct sbiret ret;
-	union sbi_pmu_ctr_info info;
 	u64 val = 0;
+	union sbi_pmu_ctr_info info = pmu_ctr_list[idx];
 
 	if (pmu_sbi_is_fw_event(event)) {
 		ret = sbi_ecall(SBI_EXT_PMU, SBI_EXT_PMU_COUNTER_FW_READ,
 				hwc->idx, 0, 0, 0, 0, 0);
 		if (!ret.error)
 			val = ret.value;
+#if defined(CONFIG_32BIT)
+		if (sbi_v2_available && info.width >= 32) {
+			ret = sbi_ecall(SBI_EXT_PMU, SBI_EXT_PMU_COUNTER_FW_READ_HI,
+					hwc->idx, 0, 0, 0, 0, 0);
+			if (!ret.error)
+				val = val | ((u64)ret.value << 32);
+		}
+#endif
 	} else {
-		info = pmu_ctr_list[idx];
 		val = riscv_pmu_ctr_read_csr(info.csr);
 		if (IS_ENABLED(CONFIG_32BIT))
 			val = ((u64)riscv_pmu_ctr_read_csr(info.csr + 0x80)) << 31 | val;
-- 
2.34.1