[PATCH v2] riscv: Make mmap() with PROT_WRITE imply PROT_READ

[Celeste Liu]

On 2022/9/9 02:50, Andrew Bresticker wrote:
> Commit 2139619bcad7 ("riscv: mmap with PROT_WRITE but no PROT_READ is
> invalid") made mmap() return EINVAL if PROT_WRITE was set wihtout
> PROT_READ with the justification that a write-only PTE is considered a
> reserved PTE permission bit pattern in the privileged spec. This check
> is unnecessary since RISC-V defines its protection_map such that PROT_WRITE
> maps to the same PTE permissions as PROT_WRITE|PROT_READ, and it is
> inconsistent with other architectures that don't support write-only PTEs,
> creating a potential software portability issue. Just remove the check
> altogether and let PROT_WRITE imply PROT_READ as is the case on other
> architectures.
> 
> Note that this also allows PROT_WRITE|PROT_EXEC mappings which were
> disallowed prior to the aforementioned commit; PROT_READ is implied in
> such mappings as well.
> 
> Fixes: 2139619bcad7 ("riscv: mmap with PROT_WRITE but no PROT_READ is invalid")
> Signed-off-by: Andrew Bresticker <abrestic at rivosinc.com>
> ---
> v1 -> v2: Update access_error() to account for write-implies-read
> ---
>  arch/riscv/kernel/sys_riscv.c | 3 ---
>  arch/riscv/mm/fault.c         | 3 ++-
>  2 files changed, 2 insertions(+), 4 deletions(-)
> 
> diff --git a/arch/riscv/kernel/sys_riscv.c b/arch/riscv/kernel/sys_riscv.c
> index 571556bb9261..5d3f2fbeb33c 100644
> --- a/arch/riscv/kernel/sys_riscv.c
> +++ b/arch/riscv/kernel/sys_riscv.c
> @@ -18,9 +18,6 @@ static long riscv_sys_mmap(unsigned long addr, unsigned long len,
>  	if (unlikely(offset & (~PAGE_MASK >> page_shift_offset)))
>  		return -EINVAL;
>  
> -	if (unlikely((prot & PROT_WRITE) && !(prot & PROT_READ)))
> -		return -EINVAL;
> -
>  	return ksys_mmap_pgoff(addr, len, prot, flags, fd,
>  			       offset >> (PAGE_SHIFT - page_shift_offset));
>  }
> diff --git a/arch/riscv/mm/fault.c b/arch/riscv/mm/fault.c
> index f2fbd1400b7c..d86f7cebd4a7 100644
> --- a/arch/riscv/mm/fault.c
> +++ b/arch/riscv/mm/fault.c
> @@ -184,7 +184,8 @@ static inline bool access_error(unsigned long cause, struct vm_area_struct *vma)
>  		}
>  		break;
>  	case EXC_LOAD_PAGE_FAULT:
> -		if (!(vma->vm_flags & VM_READ)) {
> +		/* Write implies read */
> +		if (!(vma->vm_flags & (VM_READ | VM_WRITE))) {
>  			return true;
>  		}
>  		break;

Hi, this did solve the problem and achieved consistency between
architectures, but I have a question.

Such a change specifies behavior for a state that should not exist,
and if, in the future, RISC-V spec specifies a different behavior
for that state (I mean, RVI itself has a history of not caring about
downstream, like Zicsr and Zifencei), it will create inconsistencies,
which is bad.

If we reject the "write but not read" state, the user gets the most direct
response: the state is not allowed so that they do not and cannot rely
on the behavior of the state. This will bring better time consistency
to the application if the spec specifies the behavior in the future.
But it lost architecture consistency.

How do you think this situation should be handled properly?

Yours,
Celeste Liu