[PATCH v2 08/12] riscv: dts: allwinner: Add MangoPi MQ Pro devicetree

Guo Ren guoren at kernel.org
Fri Nov 25 16:25:56 PST 2022


Reviewed-by: Guo Ren <guoren at kernel.org>

On Sat, Nov 26, 2022 at 7:47 AM Samuel Holland <samuel at sholland.org> wrote:
>
> The MangoPi MQ Pro is a tiny SBC with a layout compatible to the
> Raspberry Pi Zero. It includes the Allwinner D1 SoC, 512M or 1G of DDR3,
> and an RTL8723DS-based WiFi/Bluetooth module.
>
> The board also exposes GPIO Port E via a connector on the end of the
> board, which can support either a camera or an RMII Ethernet PHY. The
> additional regulators supply that connector.
>
> Signed-off-by: Samuel Holland <samuel at sholland.org>
> ---
>
> Changes in v2:
>  - Added LED (GPIO shared between onboard LED and backlight regulator)
>
>  arch/riscv/boot/dts/allwinner/Makefile        |   1 +
>  .../allwinner/sun20i-d1-mangopi-mq-pro.dts    | 143 ++++++++++++++++++
>  2 files changed, 144 insertions(+)
>  create mode 100644 arch/riscv/boot/dts/allwinner/sun20i-d1-mangopi-mq-pro.dts
>
> diff --git a/arch/riscv/boot/dts/allwinner/Makefile b/arch/riscv/boot/dts/allwinner/Makefile
> index f1c70b9dc9bf..2ed586fafaea 100644
> --- a/arch/riscv/boot/dts/allwinner/Makefile
> +++ b/arch/riscv/boot/dts/allwinner/Makefile
> @@ -3,5 +3,6 @@ dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-lichee-rv-86-panel-480p.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-lichee-rv-86-panel-720p.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-lichee-rv-dock.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-lichee-rv.dtb
> +dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-mangopi-mq-pro.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1-nezha.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun20i-d1s-mangopi-mq.dtb
> diff --git a/arch/riscv/boot/dts/allwinner/sun20i-d1-mangopi-mq-pro.dts b/arch/riscv/boot/dts/allwinner/sun20i-d1-mangopi-mq-pro.dts
> new file mode 100644
> index 000000000000..6d5897dc22e2
> --- /dev/null
> +++ b/arch/riscv/boot/dts/allwinner/sun20i-d1-mangopi-mq-pro.dts
> @@ -0,0 +1,143 @@
> +// SPDX-License-Identifier: (GPL-2.0+ or MIT)
> +// Copyright (C) 2022 Samuel Holland <samuel at sholland.org>
> +
> +#include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/leds/common.h>
> +
> +/dts-v1/;
> +
> +#include "sun20i-d1.dtsi"
> +#include "sun20i-common-regulators.dtsi"
> +
> +/ {
> +       model = "MangoPi MQ Pro";
> +       compatible = "widora,mangopi-mq-pro", "allwinner,sun20i-d1";
> +
> +       aliases {
> +               ethernet0 = &rtl8723ds;
> +               mmc0 = &mmc0;
> +               serial0 = &uart0;
> +       };
> +
> +       chosen {
> +               stdout-path = "serial0:115200n8";
> +       };
> +
> +       leds {
> +               compatible = "gpio-leds";
> +
> +               led-0 {
> +                       color = <LED_COLOR_ID_BLUE>;
> +                       function = LED_FUNCTION_BACKLIGHT;
> +                       gpios = <&pio 3 18 GPIO_ACTIVE_HIGH>; /* PD18 */
> +               };
> +       };
> +
> +       reg_avdd2v8: avdd2v8 {
> +               compatible = "regulator-fixed";
> +               regulator-name = "avdd2v8";
> +               regulator-min-microvolt = <2800000>;
> +               regulator-max-microvolt = <2800000>;
> +               vin-supply = <&reg_vcc_3v3>;
> +       };
> +
> +       reg_dvdd: dvdd {
> +               compatible = "regulator-fixed";
> +               regulator-name = "dvdd";
> +               regulator-min-microvolt = <1200000>;
> +               regulator-max-microvolt = <1200000>;
> +               vin-supply = <&reg_vcc_3v3>;
> +       };
> +
> +       reg_vdd_cpu: vdd-cpu {
> +               compatible = "regulator-fixed";
> +               regulator-name = "vdd-cpu";
> +               regulator-min-microvolt = <1100000>;
> +               regulator-max-microvolt = <1100000>;
> +               vin-supply = <&reg_vcc>;
> +       };
> +
> +       wifi_pwrseq: wifi-pwrseq {
> +               compatible = "mmc-pwrseq-simple";
> +               reset-gpios = <&pio 6 17 GPIO_ACTIVE_LOW>; /* PG17 */
> +       };
> +};
> +
> +&cpu0 {
> +       cpu-supply = <&reg_vdd_cpu>;
> +};
> +
> +&dcxo {
> +       clock-frequency = <24000000>;
> +};
> +
> +&ehci1 {
> +       status = "okay";
> +};
> +
> +&mmc0 {
> +       bus-width = <4>;
> +       cd-gpios = <&pio 5 6 GPIO_ACTIVE_HIGH>; /* PF6 */
> +       disable-wp;
> +       vmmc-supply = <&reg_vcc_3v3>;
> +       vqmmc-supply = <&reg_vcc_3v3>;
> +       pinctrl-0 = <&mmc0_pins>;
> +       pinctrl-names = "default";
> +       status = "okay";
> +};
> +
> +&mmc1 {
> +       bus-width = <4>;
> +       mmc-pwrseq = <&wifi_pwrseq>;
> +       non-removable;
> +       vmmc-supply = <&reg_vcc_3v3>;
> +       vqmmc-supply = <&reg_vcc_3v3>;
> +       pinctrl-0 = <&mmc1_pins>;
> +       pinctrl-names = "default";
> +       status = "okay";
> +
> +       rtl8723ds: wifi at 1 {
> +               reg = <1>;
> +               interrupt-parent = <&pio>;
> +               interrupts = <6 10 IRQ_TYPE_LEVEL_LOW>; /* PG10 */
> +               interrupt-names = "host-wake";
> +       };
> +};
> +
> +&ohci1 {
> +       status = "okay";
> +};
> +
> +&pio {
> +       vcc-pe-supply = <&reg_avdd2v8>;
> +};
> +
> +&uart0 {
> +       pinctrl-0 = <&uart0_pb8_pins>;
> +       pinctrl-names = "default";
> +       status = "okay";
> +};
> +
> +&uart1 {
> +       uart-has-rtscts;
> +       pinctrl-0 = <&uart1_pg6_pins>, <&uart1_pg8_rts_cts_pins>;
> +       pinctrl-names = "default";
> +       status = "okay";
> +
> +       bluetooth {
> +               compatible = "realtek,rtl8723ds-bt";
> +               device-wake-gpios = <&pio 6 18 GPIO_ACTIVE_HIGH>; /* PG18 */
> +               enable-gpios = <&pio 6 15 GPIO_ACTIVE_HIGH>; /* PG15 */
> +               host-wake-gpios = <&pio 6 14 GPIO_ACTIVE_HIGH>; /* PG14 */
> +       };
> +};
> +
> +&usb_otg {
> +       dr_mode = "peripheral";
> +       status = "okay";
> +};
> +
> +&usbphy {
> +       usb1_vbus-supply = <&reg_vcc>;
> +       status = "okay";
> +};
> --
> 2.37.4
>


-- 
Best Regards
 Guo Ren



More information about the linux-riscv mailing list