[PATCH v5 06/12] dt-bindings: pwm: add microchip corepwm binding
conor.dooley at microchip.com
conor.dooley at microchip.com
Wed Feb 2 04:35:44 PST 2022
>On 01/02/2022 07:58, Uwe Kleine-König wrote:
>> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
>> On Mon, Jan 31, 2022 at 11:47:21AM +0000, conor.dooley at microchip.com wrote:
>> From: Conor Dooley <conor.dooley at microchip.com>
>>
>> Add device tree bindings for the Microchip fpga fabric based "core" PWM
>> controller.
>>
>> Reviewed-by: Rob Herring <robh at kernel.org>
>>
>> Signed-off-by: Conor Dooley <conor.dooley at microchip.com>
>> ---
>> .../bindings/pwm/microchip,corepwm.yaml | 75 +++++++++++++++++++
<snip>
>> + microchip,sync-update:
>> + description: |
>> + In synchronous mode, all channels are updated at the beginning of the PWM period.
>> + Asynchronous mode is relevant to applications such as LED control, where
>> + synchronous updates are not required. Asynchronous mode lowers the area size,
>> + reducing shadow register requirements. This can be set at run time, provided
>> + SHADOW_REG_EN is asserted. SHADOW_REG_EN is set by the FPGA bitstream programmed
>> + to the device.
>> + Each bit corresponds to a PWM channel & represents whether synchronous mode is
>> + possible for the PWM channel.
>> +
>> + $ref: /schemas/types.yaml#/definitions/uint16
>> + default: 0
>
>I'm not sure I understand this correctly. This is a soft-core and you
>can synthesize it either with or without the ability to do synchronous
>updates or not, right? All 16 channels share the same period length and
>in the simple implementation changing the duty cycle is done at once
>(maybe introducing a glitch) and in the more expensive implementation
>there is a register to implement both variants?
Correct. If the IP is instantiated with SHADOW_REG_ENx=1, both
registers that control the duty cycle for channel x have a second
"shadow reg" synthesised. At runtime a bit wide register exposed to
APB can be used to toggle on/off synchronised mode for all channels
it has been synthesised for.
I will reword this description since it is not clear.
>> + microchip,dac-mode:
>> + description: |
>> + Optional, per-channel Low Ripple DAC mode is possible on this IP core. It creates
>> + a minimum period pulse train whose High/Low average is that of the chosen duty
>> + cycle. This "DAC" will have far better bandwidth and ripple performance than the
>> + standard PWM algorithm can achieve.
>> + Each bit corresponds to a PWM channel & represents whether dac mode is enabled
>> + that PWM channel.
>
>In the last sentence a "for" is missing?
It is missing, thanks.
>These two properties are not detectable in software?
Unfortunately not. THe configuration for these options are only
accessible in the fpga design. You make a good point however & they
really should be visible to software. I'll suggest that for future
revisions of this IP that both configurations are accessible over APB
Thanks,
Conor.
More information about the linux-riscv
mailing list