[PATCH 1/2] firmware: include drivers/firmware/Kconfig unconditionally

Charles Keepax ckeepax at opensource.cirrus.com
Tue Sep 28 02:24:00 PDT 2021


On Tue, Sep 28, 2021 at 10:51:36AM +0200, Arnd Bergmann wrote:
> On Tue, Sep 28, 2021 at 10:37 AM Charles Keepax
> <ckeepax at opensource.cirrus.com> wrote:
> > I guess the question might be where else would said code go?
> > drivers/firmware seemed most obvious, all the other locations
> > I can think of don't really make sense. Can't really put it a bus
> > like spi/i2c etc. because we have parts on many buses. Can't
> > really put it in a functional subsystem (audio/input etc.) since
> > the whole idea was to try and get some independence from that so
> > we don't have parts including subsystems they don't use. Could
> > maybe put it in MFD, but no hard guarantee every part using it
> > will be an MFD device and I am fairly confident Lee will feel it
> > isn't MFD code as it doesn't relate to managing multiple devices.
> > Only other option I can think of would be to make some sort of
> > drivers/dsp or maybe drivers/cs_dsp, but not clear to me that is
> > obviously better than using drivers/firmware.
> 
> Other DSPs use the drivers/remoteproc/ subsystem, but that
> is more for general-purpose DSPs that can load application
> specific firmware rather than loading a single firmware blob
> as you'd normally do with the request_firmware() style interface.
> 
> Not sure if that fits what you do. Can you point to a high-level
> description of what this DSP does besides audio, and how
> flexible it is? That might help find the right place for this.

Hm... wasn't aware of that one, we should probably investigate that
a little more at this end. From a quick look, seems a bit more like
it is designed for much larger more general purpose probably memory
mapped DSPs. I guess our code is a little more firmware parsing
and loading, and a bit less generic remote proceedure call stuff.

I am not sure there is great deal available publically on the
DSP core. It is talked about in a few of our datasheets, see
section 4.4 in [1]. But a basic description might be it is a
signal processing focused, very small DSP core. If can be loaded
with different firmwares at runtime, and indeed might be doing say
echo cancellation in one use-case, or always on voice detect in
another. Functionally it is very unlikely to be used for anything
besides signal processing inside the device it is in, since it is
typically quite integrated with that hardware and will be sitting
behind a slow bus, like I2C or SPI.

Current users are all audio, planning to upstream some haptics
parts soon, with possible other uses in the future.

[1] https://statics.cirrus.com/pubs/proDatasheet/CS48L32_DS1219F4.pdf

Thanks,
Charles



More information about the linux-riscv mailing list