[PATCH 03/32] spi: dw: Fix driving MOSI low while recieving

[Damien Le Moal]

Fix for the Synopsis DesignWare SPI mmio driver taken from the work
by Sean Anderson for the U-Boot project. Sean comments:

The resting state of MOSI is high when nothing is driving it. If we
drive it low while recieving, it looks like we are transmitting 0x00
instead of transmitting nothing. This can confuse slaves (like SD cards)
which allow new commands to be sent over MOSI while they are returning
data over MISO. The return of MOSI from 0 to 1 at the end of recieving
a byte can look like a start bit and a transmission bit to an SD card.
This will cause the card to become out-of-sync with the SPI device, as
it thinks the device has already started transmitting two bytes of a new
command. The mmc-spi driver will not detect the R1 response from the SD
card, since it is sent too early, and offset by two bits. This patch
fixes transfer errors when using SD cards with dw spi.

Signed-off-by: Sean Anderson <seanga2 at gmail.com>
Signed-off-by: Damien Le Moal <damien.lemoal at wdc.com>
---
 drivers/spi/spi-dw-core.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/spi/spi-dw-core.c b/drivers/spi/spi-dw-core.c
index 841c85247f01..c2ef1d8d46d5 100644
--- a/drivers/spi/spi-dw-core.c
+++ b/drivers/spi/spi-dw-core.c
@@ -137,7 +137,7 @@ static inline u32 rx_max(struct dw_spi *dws)
 static void dw_writer(struct dw_spi *dws)
 {
 	u32 max = tx_max(dws);
-	u16 txw = 0;
+	u16 txw = 0xffff;
 
 	while (max--) {
 		if (dws->tx) {
-- 
2.28.0