[PATCH 2/2] riscv: Use PUD/PGDIR entries for linear mapping when possible
Alex Ghiti
alex at ghiti.fr
Mon Jun 29 10:42:12 EDT 2020
Hi Atish,
Le 6/22/20 à 3:11 PM, Atish Patra a écrit :
> On Sun, Jun 21, 2020 at 2:39 AM Alex Ghiti <alex at ghiti.fr> wrote:
>>
>> Hi Atish,
>>
>> Le 6/20/20 à 5:04 AM, Alex Ghiti a écrit :
>>> Hi Atish,
>>>
>>> Le 6/19/20 à 2:16 PM, Atish Patra a écrit :
>>>> On Thu, Jun 18, 2020 at 9:28 PM Alex Ghiti <alex at ghiti.fr> wrote:
>>>>> Hi Atish,
>>>>>
>>>>> Le 6/18/20 à 8:47 PM, Atish Patra a écrit :
>>>>>> On Wed, Jun 3, 2020 at 8:38 AM Alexandre Ghiti <alex at ghiti.fr> wrote:
>>>>>>> Improve best_map_size so that PUD or PGDIR entries are used for
>>>>>>> linear
>>>>>>> mapping when possible as it allows better TLB utilization.
>>>>>>>
>>>>>>> Signed-off-by: Alexandre Ghiti <alex at ghiti.fr>
>>>>>>> ---
>>>>>>> arch/riscv/mm/init.c | 45
>>>>>>> +++++++++++++++++++++++++++++++++-----------
>>>>>>> 1 file changed, 34 insertions(+), 11 deletions(-)
>>>>>>>
>>>>>>> diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
>>>>>>> index 9a5c97e091c1..d275f9f834cf 100644
>>>>>>> --- a/arch/riscv/mm/init.c
>>>>>>> +++ b/arch/riscv/mm/init.c
>>>>>>> @@ -424,13 +424,29 @@ static void __init create_pgd_mapping(pgd_t
>>>>>>> *pgdp,
>>>>>>> create_pgd_next_mapping(nextp, va, pa, sz, prot);
>>>>>>> }
>>>>>>>
>>>>>>> -static uintptr_t __init best_map_size(phys_addr_t base,
>>>>>>> phys_addr_t size)
>>>>>>> +static bool is_map_size_ok(uintptr_t map_size, phys_addr_t base,
>>>>>>> + uintptr_t base_virt, phys_addr_t size)
>>>>>>> {
>>>>>>> - /* Upgrade to PMD_SIZE mappings whenever possible */
>>>>>>> - if ((base & (PMD_SIZE - 1)) || (size & (PMD_SIZE - 1)))
>>>>>>> - return PAGE_SIZE;
>>>>>>> + return !((base & (map_size - 1)) || (base_virt & (map_size
>>>>>>> - 1)) ||
>>>>>>> + (size < map_size));
>>>>>>> +}
>>>>>>> +
>>>>>>> +static uintptr_t __init best_map_size(phys_addr_t base, uintptr_t
>>>>>>> base_virt,
>>>>>>> + phys_addr_t size)
>>>>>>> +{
>>>>>>> +#ifndef __PAGETABLE_PMD_FOLDED
>>>>>>> + if (is_map_size_ok(PGDIR_SIZE, base, base_virt, size))
>>>>>>> + return PGDIR_SIZE;
>>>>>>> +
>>>>>>> + if (pgtable_l4_enabled)
>>>>>>> + if (is_map_size_ok(PUD_SIZE, base, base_virt, size))
>>>>>>> + return PUD_SIZE;
>>>>>>> +#endif
>>>>>>> +
>>>>>>> + if (is_map_size_ok(PMD_SIZE, base, base_virt, size))
>>>>>>> + return PMD_SIZE;
>>>>>>>
>>>>>>> - return PMD_SIZE;
>>>>>>> + return PAGE_SIZE;
>>>>>>> }
>>>>>>>
>>>>>>> /*
>>>>>>> @@ -576,7 +592,7 @@ void create_kernel_page_table(pgd_t *pgdir,
>>>>>>> uintptr_t map_size)
>>>>>>> asmlinkage void __init setup_vm(uintptr_t dtb_pa)
>>>>>>> {
>>>>>>> uintptr_t va, end_va;
>>>>>>> - uintptr_t map_size = best_map_size(load_pa,
>>>>>>> MAX_EARLY_MAPPING_SIZE);
>>>>>>> + uintptr_t map_size;
>>>>>>>
>>>>>>> load_pa = (uintptr_t)(&_start);
>>>>>>> load_sz = (uintptr_t)(&_end) - load_pa;
>>>>>>> @@ -587,6 +603,7 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa)
>>>>>>>
>>>>>>> kernel_virt_addr = KERNEL_VIRT_ADDR;
>>>>>>>
>>>>>>> + map_size = best_map_size(load_pa, PAGE_OFFSET,
>>>>>>> MAX_EARLY_MAPPING_SIZE);
>>>>>>> va_pa_offset = PAGE_OFFSET - load_pa;
>>>>>>> va_kernel_pa_offset = kernel_virt_addr - load_pa;
>>>>>>> pfn_base = PFN_DOWN(load_pa);
>>>>>>> @@ -700,6 +717,8 @@ static void __init setup_vm_final(void)
>>>>>>>
>>>>>>> /* Map all memory banks */
>>>>>>> for_each_memblock(memory, reg) {
>>>>>>> + uintptr_t remaining_size;
>>>>>>> +
>>>>>>> start = reg->base;
>>>>>>> end = start + reg->size;
>>>>>>>
>>>>>>> @@ -707,15 +726,19 @@ static void __init setup_vm_final(void)
>>>>>>> break;
>>>>>>> if (memblock_is_nomap(reg))
>>>>>>> continue;
>>>>>>> - if (start <= __pa(PAGE_OFFSET) &&
>>>>>>> - __pa(PAGE_OFFSET) < end)
>>>>>>> - start = __pa(PAGE_OFFSET);
>>>>>>>
>>>>>>> - map_size = best_map_size(start, end - start);
>>>>>>> - for (pa = start; pa < end; pa += map_size) {
>>>>>>> + pa = start;
>>>>>>> + remaining_size = reg->size;
>>>>>>> +
>>>>>>> + while (remaining_size) {
>>>>>>> va = (uintptr_t)__va(pa);
>>>>>>> + map_size = best_map_size(pa, va,
>>>>>>> remaining_size);
>>>>>>> +
>>>>>>> create_pgd_mapping(swapper_pg_dir, va, pa,
>>>>>>> map_size, PAGE_KERNEL);
>>>>>>> +
>>>>>>> + pa += map_size;
>>>>>>> + remaining_size -= map_size;
>>>>>>> }
>>>>>>> }
>>>>>>>
>>>>>> This may not work in the RV32 with 2G memory and if the map_size is
>>>>>> determined to be a page size
>>>>>> for the last memblock. Both pa & remaining_size will overflow and the
>>>>>> loop will try to map memory from zero again.
>>>>> I'm not sure I understand: if pa starts at 0x8000_0000 and size is 2G,
>>>>> then pa will overflow in the last iteration, but remaining_size will
>>>>> then be equal to 0 right ?
>>>>>
>>>> Not unless the remaining_size is at least page size aligned. The last
>>>> remaining size would "fff".
>>>> It will overflow as well after subtracting the map_size.
>>
>>
>> While fixing this issue, I noticed that if the size in the device tree
>> is not aligned on PAGE_SIZE, the size is then automatically realigned on
>> PAGE_SIZE: see early_init_dt_add_memory_arch where size is and-ed with
>> PAGE_MASK to remove the unaligned part.
>>
> Yes. But the memblock size is not guaranteed to be PAGE_SIZE aligned.
> The memblock size is updated in memblock_cap_size
>
> /* adjust *@size so that (@base + *@size) doesn't overflow, return
> new size */
> static inline phys_addr_t memblock_cap_size(phys_addr_t base,
> phys_addr_t *size)
> {
> return *size = min(*size, PHYS_ADDR_MAX - base);
> }
>
Yes you're right, I will fix that in a v2.
Thanks,
Alex
> You will not see this issue right away even if you allocate 2GB of
> memory while running 32 bit linux in qemu
> because the kernel removes anything beyond 0xc0400000 for 32 bit in
> bootmem setup.
>
> │[ 0.000000][ T0] memblock_remove: [0xc0400000-0xfffffffe]
> setup_bootmem+0x90/0x216
>
> This also restricts the kernel to use only 1GB of memory even if
> maximum physical memory supported is 2GB.
>
>> So the issue does not need to be fixed :)
>>
>> Thanks anyway,
>>
>> Alex
>>
>>
>>>>
>>>>> And by the way, I realize that this loop only handles sizes that are
>>>>> aligned on map_size.
>>>>>
>>>> Yeah.
>>>
>>>
>>> Thanks for noticing, I send a v2.
>>>
>>> Alex
>>>
>>>
>>>>
>>>>> Thanks,
>>>>>
>>>>> Alex
>>>>>
>>>>>
>>>>>>> --
>>>>>>> 2.20.1
>>>>>>>
>>>>>>>
>>>>
>>>>
>>>
>
>
>
> --
> Regards,
> Atish
>
More information about the linux-riscv
mailing list