[PATCH v6 02/22] riscv: Fix sifive serial driver
Damien Le Moal
damien.lemoal at wdc.com
Wed Dec 9 00:34:46 EST 2020
Setup the port uartclk in sifive_serial_probe() so that the base baud
rate is correctly printed during device probe instead of always showing
"0". I.e. the probe message is changed from
38000000.serial: ttySIF0 at MMIO 0x38000000 (irq = 1,
base_baud = 0) is a SiFive UART v0
to the correct:
38000000.serial: ttySIF0 at MMIO 0x38000000 (irq = 1,
base_baud = 115200) is a SiFive UART v0
Signed-off-by: Damien Le Moal <damien.lemoal at wdc.com>
---
drivers/tty/serial/sifive.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/tty/serial/sifive.c b/drivers/tty/serial/sifive.c
index 13eadcb8aec4..214bf3086c68 100644
--- a/drivers/tty/serial/sifive.c
+++ b/drivers/tty/serial/sifive.c
@@ -999,6 +999,7 @@ static int sifive_serial_probe(struct platform_device *pdev)
/* Set up clock divider */
ssp->clkin_rate = clk_get_rate(ssp->clk);
ssp->baud_rate = SIFIVE_DEFAULT_BAUD_RATE;
+ ssp->port.uartclk = ssp->baud_rate * 16;
__ssp_update_div(ssp);
platform_set_drvdata(pdev, ssp);
--
2.28.0
More information about the linux-riscv
mailing list