[PATCH v4 2/2] phy: stm32: Add support for ST STM32MP25 USB2-FEMTO PHY

[Marek Vasut]

On 9/2/26 9:52 AM, Fabrice Gasnier wrote:

[...]

>> +static int stm32_usb2phy_set_mode(struct phy *phy, enum phy_mode mode, int submode)
>> +{
>> +	struct stm32_usb2phy *phy_dev = phy_get_drvdata(phy);
>> +	u32 mask = SYSCFG_USB2PHY2CR_USB2PHY2CMN |
>> +		   SYSCFG_USB2PHY2CR_VBUSVALID |
>> +		   SYSCFG_USB2PHY2CR_VBUSVLDEXT;
>> +	u32 val = 0;
>> +	int ret;
>> +
>> +	if (mode == PHY_MODE_USB_HOST) {
>> +		if (submode != USB_ROLE_NONE)
>> +			val = SYSCFG_USB2PHY2CR_VBUSVALID;
>> +	} else if (mode == PHY_MODE_USB_DEVICE) {
>> +		val = SYSCFG_USB2PHY2CR_USB2PHY2CMN |
>> +		      SYSCFG_USB2PHY2CR_VBUSVLDEXTSEL;
>> +		if (submode != USB_ROLE_NONE)
>> +			val |= SYSCFG_USB2PHY2CR_VBUSVLDEXT;
>> +		mask |= SYSCFG_USB2PHY2CR_VBUSVLDEXTSEL;
>> +	} else {
>> +		return -EINVAL;
>> +	}
>> +
>> +	ret = regmap_update_bits(phy_dev->regmap, phy_dev->cr_offset, mask, val);
>> +	if (ret)
>> +		return ret;
>> +
>> +	phy_dev->mode = mode;
> 
> Hello Marek,
> 
> The 'mode' is used typically when exiting low power mode. Should keep
> track of the submode too here. See next comment.
> 
>> +
>> +	return 0;
>> +}
>> +
>> +static int stm32_usb2phy1_init(struct phy *phy)
>> +{
>> +	struct stm32_usb2phy *phy_dev = phy_get_drvdata(phy);
>> +	int ret;
>> +
>> +	ret = stm32_usb2phy_enable(phy_dev);
>> +	if (ret)
>> +		return ret;
>> +
>> +	phy_dev->is_init = true;
>> +
>> +	return 0;
>> +}
>> +
>> +static int stm32_usb2phy2_init(struct phy *phy)
>> +{
>> +	struct stm32_usb2phy *phy_dev = phy_get_drvdata(phy);
>> +	int ret;
>> +
>> +	ret = stm32_usb2phy_enable(phy_dev);
>> +	if (ret)
>> +		return ret;
>> +
>> +	if (phy_dev->mode != PHY_MODE_INVALID) {
>> +		ret = stm32_usb2phy_set_mode(phy, phy_dev->mode, USB_ROLE_NONE);
> 
> This part restores the mode, when existing from low power: Controller
> driver (dwc3) calls phy_init/power_on. The submode should be restored
> too here, instead of USB_ROLE_NONE.
Will do in V5, thanks !