[PATCH v2 3/7] media: qcom: camss: Allow CSI2 PHY devices without CSIPHY resources

[Nihal Kumar Gupta]

On 31-10-2026 20:44, Loic Poulain wrote:
>> Bryan, Loic, do you think we need that change now, or should Glymur keep
>> the current approach for this DTS series?
> I see in the following in your Glymur series:
> port at 3 {
>    reg = <3>;
>    camss_csiphy4_inep: endpoint {
>    remote-endpoint = <&csiphy4_out_ep>;
> };
> 
> Which CAMSS pipeline interface index/instance is CSIPHY4 connected to?
> If it is connected to interface 4 on CAMSS side, then we should use
> port at 4.

CSIPHY4 is connected to CAMSS interface/index 4, so the DT should describe
it as port at 4 for a direct one-to-one hardware mapping. 

I will raise a patch to update that.
-- 
Regards,
Nihal Kumar Gupta