[PATCH v23 08/15] media: qcom: camss: csiphy: Add support for v2.4.0 two-phase CSIPHY

[Vladimir Zapolskiy]

Hello Hangxiang.

On 10/28/26 17:20, Hangxiang Ma wrote:
> Add support for the v2.4.0 two-phase CSIPHY found on Kaanapali, where
> the PHY is driven by the standalone phy-qcom-mipi-csi2 DPHY driver
> rather than by CAMSS. Add the mipi_csi2_dphy_3nm_kaanapali configuration,
> which reuses the x1e80100 lane sequence, clocks and supplies but selects
> the v2.4.0 common status offset, adds Kaanapali power domain and register
> the "qcom,kaanapali-csi2-phy" compatible.
> 
> Reviewed-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>
> Signed-off-by: Hangxiang Ma <hangxiang.ma at oss.qualcomm.com>
> ---
>   drivers/media/platform/qcom/camss/camss.c | 47 +++++++++++++++++++++++++++++++
>   1 file changed, 47 insertions(+)
> 
> diff --git a/drivers/media/platform/qcom/camss/camss.c b/drivers/media/platform/qcom/camss/camss.c
> index a64242c66cf0..b0b63dd3d958 100644
> --- a/drivers/media/platform/qcom/camss/camss.c
> +++ b/drivers/media/platform/qcom/camss/camss.c
> @@ -38,6 +38,51 @@
>   
>   static const struct parent_dev_ops vfe_parent_dev_ops;
>   
> +static const struct camss_subdev_resources csiphy_res_kaanapali[] = {
> +	/* CSIPHY0 */
> +	{
> +		.csiphy = {
> +			.id = 0,
> +			.formats = &csiphy_formats_sdm845
> +		},
> +	},
It makes no sense to bloat the code for no good reason, especially if
these empty tables are to be added for every new supported platform.

CSIPHYs is not a part of the CAMSS on this platform, hence resources
shall not be statically allocated for CSIPHYs in the CAMSS driver.

See also https://lore.kernel.org/linux-arm-msm/20261026224957.1115370-1-vz@kernel.org

-- 
Best wishes,
Vladimir