[PATCH v3 5/5] media: qcom: camss: Add support for Hawi

[Hangxiang Ma]

On 10/30/2026 11:04 PM, Bryan O'Donoghue wrote:
> On 30/10/2026 12:43, Nihal Kumar Gupta wrote:
>> +static const struct camss_subdev_resources csid_res_hawi[] = {
>> +    /* CSID0 */
>> +    {
>> +        .clock = { "csid", "csid_csiphy_rx" },
>> +        .clock_rate = { { 480000000 },
>> +                { 480000000 } },
>> +        .reg = { "csid0" },
>> +        .interrupt = { "csid0" },
>> +        .csid = {
>> +            .parent_dev_ops = &vfe_parent_dev_ops,
>> +            .hw_ops = &csid_ops_1190,
>> +            .formats = &csid_formats_gen2
>> +        }
> 
> This looks strange, why is there only one clock rate ?
> 
> ---
> bod
Hi Bryan, the current CAMSS CSID code always selects the first frequency 
listed for each clock in the CAMSS resource table.

In camss-csid.c:

[...]
} else if (clock->nfreqs) {
         clk_set_rate(clock->clk, clock->freq[0]);
}
[...]

For the CSID and CSID_CSIPHY_RX clocks, the hardware supports three 
clock rates: 200 MHz, 300 MHz, and 480 MHz. If I remember correctly, 
200MHz and 300 MHz is not sufficient for the sensor's output pixel rate, 
so we need to use the highest rate, 480 MHz, to meet the bandwidth 
requirement. Thanks a lot.

---
Best Regards,
Hangxiang