[PATCH v3 0/5] Add CAMSS support for Qualcomm Hawi and Maili

[Nihal Kumar Gupta]

Hawi and Maili are recently announced Qualcomm Snapdragon SoCs [1].
This series adds Camera Subsystem (CAMSS) support for the Qualcomm
Hawi and Maili SoC's.

[1] https://www.qualcomm.com/smartphones/products/8-series/snapdragon-8-elite-gen-6-mobile-platform

Hawi's camera hardware topology:
- 6x CSIPHY (CSI Physical Layer)
- 3x TPG (Test Pattern Generator)
- 3x CSID (CSI Decoder)
- 2x CSID Lite
- 3x VFE (Video Front End), 5 RDI per VFE
- 2x VFE Lite, 4 RDI per VFE Lite

Maili shares the same IP as Hawi. The only difference is Hawi has 6 CSIPHY
while Maili has 5.

Used following tools for the sanity check of these changes.
- make -j32 W=1
- checkpatch.pl
- make DT_CHECKER_FLAGS=-m W=1 DT_SCHEMA_FILES=i2c/qcom,i2c-cci.yaml dt_binding_check
- make DT_CHECKER_FLAGS=-m DT_SCHEMA_FILES=media/qcom,hawi-camss.yaml dt_binding_check W=1
- make CHECK_DTBS=y W=1 dtbs

Dependencies
------------
[1] https://lore.kernel.org/all/20261028-kaanapali-camss-v23-0-95f250b18612@oss.qualcomm.com/ -- Kaanapali CAMSS driver and bindings

Patch grouping
------------
I2C CCI bindings part for maintainer Loic/Robert/Andi (1):
[1] dt-bindings: i2c: qcom,i2c-cci: Add Hawi compatible

PHY driver part for maintainer Vinod Koul (2):
[2] dt-bindings: phy: qcom,x1e80100-csi2-phy: Add Hawi and Maili compatibles
[4] phy: qcom-mipi-csi2: Add Hawi support

CAMSS driver and DTS part for maintainer Bryan O'Donoghue (5):
[3] dt-bindings: media: Add CAMSS device for Hawi and Maili
[5] media: qcom: camss: Add support for Hawi

---
Changes in v3:
- Rebase on next-20261029
- Squash Hawi and Maili CAMSS binding as a whole - Krzysztof
- Add description for IFE and IFE_LITE IOMMU in CAMSS binding - bod
- Correct the lane count variable fallback path - Sashiko
- Add CAMSS top region to binding and DT - Loic
- Use split addr_update/reg_update in CSID and VFE 1190 - Loic/bod
- Add SOF and EOF enable bits with top level RDI status offset to
  allow their corresponding interrupts but not configured on - bod
- Move the common CPAS/GCC AHB and AXI clocks to the pm_clks array
  drop them from the VFE clock lists - Loic
- Use the GPIO function with bias disabled for CCI sleep states - Loic
- Collect RBs from Loic, Krzysztof and bod
- Link to v2: https://lore.kernel.org/r/20261013-hawi-maili-camss-v2-0-fc93222da89c@oss.qualcomm.com

Changes in v2:
- Not an RFC anymore
- Rebase on next-20261012 and drop the external CSI2 PHY series dependency. 
- Drop DTS patches; they will be posted separately with Maili DTS dependency.
- Collect Reviewed-by from Konrad, Abel, Bryan
- Split CSID and VFE 1190 into individual files rather than in separate
  combined Gen4 files - bod
- Remove reduandant is_lite condition in CAMSS CSID and VFE resources - bod
- Replace bias-pull-up and bias-pull-down with bias-disable for the
  SCL/SDA pins of CCI nodes in TLMM, as internal weak pull is inproper
  with existing board level pull up resistors - Loic
- Drop the unused reg_update_after_csid_config flag
- Add lane count fallback path for CSID RX configuration
- Add Hawi DPHY support by tuning register table, which prevents
  potential stream stalls and SMMU faults.
- Add a standalone Hawi CSI2 PHY compatible and make Maili fall back to it.
- Resolve conflicts introduced by Glymur in CSI2 PHY binding.
- Link to v1: https://lore.kernel.org/r/20260923-hawi-maili-camss-v1-0-cbbb42e534ef@oss.qualcomm.com

Signed-off-by: Nihal Kumar Gupta <nihal.gupta at oss.qualcomm.com>

---
Hangxiang Ma (4):
      dt-bindings: i2c: qcom,i2c-cci: Add Hawi compatible
      dt-bindings: media: Add CAMSS device for Hawi and Maili
      phy: qcom-mipi-csi2: Add Hawi support
      media: qcom: camss: Add support for Hawi

Nihal Kumar Gupta (1):
      dt-bindings: phy: qcom,x1e80100-csi2-phy: Add Hawi and Maili compatibles

 .../devicetree/bindings/i2c/qcom,i2c-cci.yaml      |   2 +
 .../devicetree/bindings/media/qcom,hawi-camss.yaml | 314 ++++++++++++++++
 .../bindings/phy/qcom,x1e80100-csi2-phy.yaml       |   5 +
 drivers/media/platform/qcom/camss/Makefile         |   2 +
 .../media/platform/qcom/camss/camss-csid-1190.c    | 417 +++++++++++++++++++++
 drivers/media/platform/qcom/camss/camss-csid.h     |   1 +
 drivers/media/platform/qcom/camss/camss-vfe-1190.c | 217 +++++++++++
 drivers/media/platform/qcom/camss/camss-vfe.c      |   2 +
 drivers/media/platform/qcom/camss/camss-vfe.h      |   1 +
 drivers/media/platform/qcom/camss/camss.c          | 229 +++++++++++
 drivers/media/platform/qcom/camss/camss.h          |   1 +
 drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c | 136 +++++++
 drivers/phy/qualcomm/phy-qcom-mipi-csi2-core.c     |   1 +
 drivers/phy/qualcomm/phy-qcom-mipi-csi2.h          |   1 +
 14 files changed, 1329 insertions(+)
---
base-commit: a39c950806213f6861d00f90729acaaa21f2d95a
change-id: 20260923-hawi-maili-camss-b5dc43a00ed2
prerequisite-patch-id: 6108fea87bf95e2911f09bbe7e95fa536c3ce397
prerequisite-patch-id: b347ad60c475f3035b04ec76741e0f1b5f095580
prerequisite-patch-id: aa51e15c5698d3425e979c810ff54968178a364b
prerequisite-patch-id: 5faef8cef855ce6fa00e2c7f10f125431ede40a4
prerequisite-patch-id: ae577f411cccd0e6cdfcfd05ea6cbfc3e87eca37
prerequisite-patch-id: 56eff00251984e6b3da63327eec1efcdb8194ef1
prerequisite-patch-id: 768be92ac0d44493176dfdcaddd24256719a3761
prerequisite-patch-id: 9908a408d5259107a6f00780d7147cddb625b02d
prerequisite-patch-id: ac9c23e579f4c3078a07d3e45373bc63729cf992
prerequisite-patch-id: d22bf3220b43f8f0bc29d0445edb7deaeb7e57b4
prerequisite-patch-id: fb4e676ec517317515f02fe4a2a482a64942c165

Best regards,
-- 
Nihal Kumar Gupta <nihal.gupta at oss.qualcomm.com>