[PATCH v23 04/15] media: qcom: camss: Add addr_update hooks and guard CSID reg_update

[Bryan O'Donoghue]

On 28/10/2026 15:20, Hangxiang Ma wrote:
>  From CSID 680 on, CAMIF was moved into the CSID and the CSID became
> responsible for issuing RUP commands. Starting with CSID 980, RUP and
> AUP are issued separately, and each command must have its corresponding
> SET bit asserted in RUP_AUP_CMD; otherwise, the hardware ignores it.
> 
> CSID 980 and newer require a specific stream-on sequence. After the RX
> is configured and before the RDI path is enabled, the CSID must first
> issue an AUP and then a RUP. A RUP issued before that point would leave
> the VFE without a BUF_DONE event. Therefore, once addr_update is set,
> the VFE must skip the initial RUP during stream-on.
> 
> Add addr_update hooks and camss_addr_update, and make camss_reg_update
> handle a missing callback safely. The VFE keeps issuing its initial RUP
> during stream-on and behavior is unchanged if nullify addr_update. The
> skip takes effect once a generation that sets addr_update is enabled.
> 
> Signed-off-by: Hangxiang Ma<hangxiang.ma at oss.qualcomm.com>

I think we should probably serialise reg_update() and addr_update() with 
the completion in the ISR but, I also think that can be done in a later 
series.

Reviewed-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>