[PATCH v23 13/15] arm64: dts: qcom: kaanapali: Add CCI controller nodes

[Abel Vesa]

On 26-10-28 08:20:47, Hangxiang Ma wrote:
> Add the three Camera Control Interface (CCI) controllers present on the
> Kaanapali SoC. Each controller provides two I2C hosts used for camera
> sensor control, so define the controller nodes and their pinctrl states.
> 
> The first bus has two CCI bus master pinouts:
> cci_i2c_sda0 = gpio109
> cci_i2c_scl0 = gpio110
> 
> cci_i2c_sda1 = gpio111
> cci_i2c_scl1 = gpio112
> 
> The second bus has two CCI bus master pinouts:
> cci_i2c_sda3 = gpio113
> cci_i2c_scl3 = gpio114
> 
> cci_i2c_sda4 = gpio107
> cci_i2c_scl4 = gpio160
> 
> The third bus has two CCI bus master pinouts:
> cci_i2c_sda5 = gpio108
> cci_i2c_scl5 = gpio149
> 
> cci_i2c_sda6 = gpio115
> cci_i2c_scl6 = gpio116
> 
> Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy at linaro.org>
> Acked-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
> Signed-off-by: Hangxiang Ma <hangxiang.ma at oss.qualcomm.com>

Reviewed-by: Abel Vesa <abel.vesa at oss.qualcomm.com>