[PATCH RFC v2 4/4] phy: qcom-mipi-csi2: Add C-PHY support for X1E80100

[Konrad Dybcio]

On 10/16/26 1:35 PM, Nihal Kumar Gupta wrote:
> 
> 
> On 16-10-2026 16:27, George Neacsu via B4 Relay wrote:
>> +	{.reg_addr = 0x0a54, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
>> +	{.reg_addr = 0x0a40, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
>> +	{.reg_addr = 0x0a60, .reg_data = 0xa8, .param_type = CSIPHY_DEFAULT_PARAMS},
>> +	{.reg_addr = 0x0a84, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
>> +	{.reg_addr = 0x0a90, .reg_data = 0x02, .param_type = CSIPHY_DEFAULT_PARAMS},
>> +
>> +	/* csiphy_reset_exit_reg_2_1_2, 3PH */
>> +	{.reg_addr = 0x1000, .reg_data = 0x0e, .delay_us = 3048,
>> +	 .param_type = CSIPHY_DEFAULT_PARAMS},
>> +};
>> +
> I checked the register settings and they look good to me.
> 
> Can we write the delay value in hex as well, to keep the table
> formatting consistent.

I don't think delay in hex makes sense to a human reader

Konrad