[PATCH] phy: qualcomm: phy-qcom-eusb2-repeater: Fix SMB Power leakage issue

[Manivannan Sadhasivam]

On Thu, Sep 17, 2026 at 03:10:09PM +0530, Krishna Kurapati wrote:
> On Glymur, it is observed that although the exit call is done, there is a
> power leakage seen on SMB2370 charger (which embeds the eUSB2 module as
> well). As per recommendation of HW team, disable the repeater during the
> exit call to prevent this power leakage.
> 
> Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
> Signed-off-by: Krishna Kurapati <krishna.kurapati at oss.qualcomm.com>
> ---
> RB tag from Konrad received on an internal reivew.
> ---
>  drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> index efeec4709a15..7db2fbff6163 100644
> --- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> +++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> @@ -229,7 +229,10 @@ static int eusb2_repeater_set_mode(struct phy *phy,
>  static int eusb2_repeater_exit(struct phy *phy)
>  {
>  	struct eusb2_repeater *rptr = phy_get_drvdata(phy);
> +	struct regmap *regmap = rptr->regmap;
> +	u32 base = rptr->base;
>  
> +	regmap_write(regmap, base + EUSB2_EN_CTL1, 0);

Can you safely write 0 to this register? Since init() just sets EUSB2_RPTR_EN,
wondering if you need to clear that bit only.

- Mani

-- 
மணிவண்ணன் சதாசிவம்