[PATCH v3 5/5] phy: qcom-qmp-ufs: Add Glymur support

[Pradeep Pragallapati]

On 10/7/2026 1:18 PM, Dmitry Baryshkov wrote:
> On Wed, Oct 07, 2026 at 11:59:38AM +0530, Pradeep P V K wrote:
>> Add the init sequence tables and config for the UFS QMP phy found in
>> the Glymur SoC.
>>
>> Reviewed-by: Abel Vesa <abel.vesa at oss.qualcomm.com>
>> Acked-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
>> Signed-off-by: Pradeep P V K <pradeep.pragallapati at oss.qualcomm.com>
>> ---
>>  drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 99 +++++++++++++++++++++++++++++++++
>>  1 file changed, 99 insertions(+)
>>
>> +	.offsets		= &qmp_ufs_offsets_v6,
> 
> So, is it a PHY using v6 offsets, but v7 registers inside?
> 
The QSERDES RX0 register offsets on Glymur SoC are aligned with the v7 register layout offsets.
Therefore, the v7 QSERDES RX0 register offsets are used for Glymur (similar to SM8750).

>> +	.max_supported_gear	= UFS_HS_G5,
>> +
>> +	.vreg_list		= glymur_ufsphy_vreg_l,
>> +	.num_vregs		= ARRAY_SIZE(glymur_ufsphy_vreg_l),
>> +	.regs			= ufsphy_v6_regs_layout,
> 
> v7
> 
>> +};
>> +
>>  static const struct qmp_phy_cfg milos_ufsphy_cfg = {
>>  	.lanes			= 2,
>>  
>