[PATCH v4 1/2] dt-bindings: phy: qcom: Add CSI2 C-PHY/DPHY schema

[Konrad Dybcio]

On 3/16/26 3:45 AM, Dmitry Baryshkov wrote:
> On Mon, Mar 16, 2026 at 03:58:14AM +0200, Vladimir Zapolskiy wrote:
>> On 3/16/26 01:52, Bryan O'Donoghue wrote:
>>> Add a base schema initially compatible with x1e80100 to describe MIPI CSI2
>>> PHY devices.
>>>
>>> The hardware can support both C-PHY and D-PHY modes. The CSIPHY devices
>>> have their own pinouts on the SoC as well as their own individual voltage
>>> rails.
>>>
>>> The need to model voltage rails on a per-PHY basis leads us to define
>>> CSIPHY devices as individual nodes.
>>>
>>> Two nice outcomes in terms of schema and DT arise from this change.
>>>
>>> 1. The ability to define on a per-PHY basis voltage rails.
>>> 2. The ability to require those voltage.
>>>
>>> We have had a complete bodge upstream for this where a single set of
>>> voltage rail for all CSIPHYs has been buried inside of CAMSS.
>>>
>>> Much like the I2C bus which is dedicated to Camera sensors - the CCI bus in
>>> CAMSS parlance, the CSIPHY devices should be individually modelled.
>>>
>>> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>
>>> ---
>>>   .../bindings/phy/qcom,x1e80100-csi2-phy.yaml       | 133 +++++++++++++++++++++
>>>   1 file changed, 133 insertions(+)
>>>
>>> +
>>> +  vdda-0p8-supply:
>>> +    description: Phandle to a 0.8V regulator supply to a PHY.
>>
>> On Hamoa the CSIPHY supply voltage is 0.88-0.92, so it is 0p9 rather than 0p8.
> 
> What is its name in the schematics or in the datasheet?

VDD_A_CSI_n_0P9

so vdda-0p9 seems fitting

Konrad