[PATCH v3 4/4] phy: qcom: qmp-usbc: Add support for "phy" reset used on Shikra

[Krishna Kurapati]

On 5/27/2026 11:57 AM, Xiangxu Yin wrote:
> 
> On 5/27/2026 2:44 AM, Pratham Pratap wrote:
>> From: Krishna Kurapati <krishna.kurapati at oss.qualcomm.com>
>>
>> Shikra uses three resets (dp/ phy/ phy_phy). Add the extra "phy" reset
>> needed for operation of QMP Phy on Shikra.
>>
>> Signed-off-by: Krishna Kurapati <krishna.kurapati at oss.qualcomm.com>
>> Signed-off-by: Pratham Pratap <pratham.pratap at oss.qualcomm.com>
>> ---
>>   drivers/phy/qualcomm/phy-qcom-qmp-usbc.c | 2 +-
>>   1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-usbc.c b/drivers/phy/qualcomm/phy-qcom-qmp-usbc.c
>> index c342479a3798..067e7f6e5642 100644
>> --- a/drivers/phy/qualcomm/phy-qcom-qmp-usbc.c
>> +++ b/drivers/phy/qualcomm/phy-qcom-qmp-usbc.c
>> @@ -513,7 +513,7 @@ static const char * const usb3phy_reset_l[] = {
>>   };
>>   
>>   static const char * const usb3dpphy_reset_l[] = {
>> -	"phy_phy", "dp_phy",
>> +	"phy_phy", "dp_phy", "phy",
>>   };
>>   
> 
> 
> usb3dpphy_reset_l is shared with qcs615_usb3dp_phy_cfg, but I didn't find any optional-reset handling in qmp_usbc_reset_init().
> talos.dtsi only defines two resets for qcom,qcs615-qmp-usb3-dp-phy, so adding "phy" here unconditionally will break probe on QCS615.
> Please create a separate reset list for Shikra instead.
> 
> 

ACK, will create a new match_data cfg for Shikra instead of reusing the 
talos one.

Regards,
Krishna,

>>   static const struct regulator_bulk_data qmp_phy_msm8998_vreg_l[] = {